Why Does My 2020 Sherco 125 SE-R Dirt Bike Leak Oil?

Shop parts for a 2020 Sherco 125SE-R Dirt Bike.

Is It Really Oil?

Before you start pulling covers apart, confirm what the fluid actually is. Many riders mistake one fluid for another, and identifying it first saves a lot of wasted time. Engine and transmission oil on a 2020 125SE-R is typically amber to dark brown, feels slick between your fingers, and smells like petroleum or burnt oil. Fork oil is thinner and clearer, and it tends to appear on the fork tubes and lower legs rather than under the engine. Brake fluid is oily in feel but has a sharp, almost sour odor, and it often looks clear to pale yellow. If you see a fluid that is pinkish or has a faint tint, check whether it came from the fuel system.

Fuel and premix are the other common culprit. Premix is thin, smells strongly of gasoline, and evaporates quickly, leaving little residue behind. If the wet spot disappears within a few minutes of sitting in the garage, you are probably looking at fuel rather than oil. Once you know what you are dealing with, the rest of the diagnosis becomes much more focused.

How to Find the Source

Start by cleaning the entire lower half of the bike with a degreaser and a brush. Old grime hides fresh leaks, and a clean surface shows you exactly where new fluid appears. Rinse, dry, and let the bike sit for a few minutes.

Next, idle the bike for several minutes or take a short ride around the property. Warm oil thins out and starts to seep from the weak point. Stop, then look carefully for fresh, wet oil rather than dark staining left from an earlier ride.

Keep in mind that oil runs downhill and gets blown backward by airflow while you ride. The drip you see on the ground or on the frame is often below and behind the real source. Trace the wet trail uphill and toward the front of the bike. A flashlight helps a great deal here, especially around the engine underside and the area behind the clutch side cover. Wipe suspected spots with a clean rag. The area that soaks the rag fastest is almost always the actual leak.

Under the Bike and Bottom of the Engine

The lowest part of the engine is where rock strikes and hard landings do their damage. On an enduro-focused 125SE-R, the underside takes hits from roots, rocks, and ledges, and a cracked case is the most serious cause of a bottom-end leak. Look for oil seeping along case seams, especially after a crash. A hairline crack may only weep, but it will grow under vibration, so do not ignore it.

The drain plug is the simplest leak to fix. If the plug or its sealing washer was disturbed during a recent oil change, it may be slightly loose or the washer may not have seated properly. Replace the washer whenever you remove the plug, because a reused washer often weeps after a few hard rides.

The countershaft seal, located where the front sprocket sits, is one of the most common leak points on dirt bikes. Chain spray and grit wear the seal lip over time, and oil slowly works its way out along the shaft and onto the sprocket and chain area. A shift shaft seal at the lever side can leak in the same way, usually showing up as a greasy film around the shifter. Both seals are inexpensive, and replacing them is a realistic garage job with basic tools.

Sides of the Engine

The side covers hold most of the gaskets that keep oil inside the cases. The clutch cover gasket is a frequent offender, and a leak here usually shows as oil around the seam of the cover or dripping down the lower edge of the engine. Cover bolts that are loose, overtightened, or pinched gasket material can all cause this, so check that the gasket sits flat before you assume it has failed.

The ignition cover gasket behaves similarly. Oil that collects behind the cover and drips from its lower edge often points to a tired gasket or a cover that has been distorted by an overtightened bolt. Age matters here too. On older 125s, gaskets harden and shrink with heat cycles, and age-hardened material is a common cause of leaks on bikes from the 1970s through the 1990s. Even on a 2020 model, gaskets that have seen many seasons can lose their grip.

If the bike has a kickstart, check the kickstart shaft seal as well. Oil on the kickstart lever area or a film around the shaft points to this seal. Clean the area thoroughly before you tighten anything, since a bolt that looks loose may simply be surrounded by old residue.

Oil at the Exhaust

Dark, oily residue dripping from the pipe joints or silencer is not a mechanical leak on a two-stroke. It is usually unburned premix, commonly called spooge. Rich jetting, too much oil in the premix, or long stretches of idling and low-speed riding allow fuel and oil to pass through the pipe without burning completely. The result is a sticky, black or brown film that collects at the header joint and drips from the silencer outlet. Adjusting your mixture ratio and running the bike harder for a few minutes at the end of a session usually reduces it. If the residue appears only after heavy idling, that is a strong clue.

Oil on the Forks

Oil on the fork tubes, fork guards, or front brake caliper usually means worn fork seals or dirty dust wipers. Wipers that have collected grit can push contaminated oil outward, while worn seals allow the fork oil to escape past the lip. Cleaning the seal area can sometimes stop a minor weep, but a seal that is actively leaking needs replacement. Fork oil on the front brake is a serious problem, because it reduces braking performance. Clean it off thoroughly with brake cleaner and a clean rag before riding the bike again.

Oil on the Rear Shock

If you see oil on the shock body, around the shaft, or on the linkage near the swingarm, the shock seal is likely leaking. A small amount of shiny film on the shaft is common after a long season, but a wet trail running down the shock body means the seal is failing. Wipe the shaft clean, ride a short distance, and check again to judge how fast it is returning.

Urgent vs. Can Wait

Some leaks need attention before the next ride. Any fluid on the brakes is a stop-now problem, whether it is fork oil, brake fluid, or engine oil. Fast or steady drips from the engine, especially from the case seams or drain plug, should be fixed before you ride, because the bike can run low on lubrication quickly. A cracked case is always urgent, even if the crack only weeps.

Light weeping from a gasket, or a thin film on a seal, can usually wait. Clean the area thoroughly, ride a few short sessions, and recheck. If the wet spot stays the same size or disappears, it is probably a minor seep that can be monitored. If it grows, move it into the urgent category.

Prevention

Inspect all covers, seals, and the case underside after every crash and rock strike, since impacts loosen bolts and shift gaskets without leaving obvious damage. Keep the fork and shock seals clean by wiping the stanchions and shock shaft after muddy rides, which slows wear on the lips. Check the drain plug and cover bolts every time you change the oil, and make sure the washer and gaskets seated properly. Finally, wash the bike regularly. A clean machine makes new leaks easy to spot, and catching a weep early is almost always cheaper than repairing a seized or damaged component later.

Related Shopping Categories

Shop Oil Seals for a 2020 Sherco 125SE-R Dirt Bike.

Shop Gaskets for a 2020 Sherco 125SE-R Dirt Bike.

Shop Fork Seals for a 2020 Sherco 125SE-R Dirt Bike.

Shop Sealant & Threadlock for a 2020 Sherco 125SE-R Dirt Bike.

Shop Skid Plates for a 2020 Sherco 125SE-R Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.