Why Does My 2011 Husaberg FE570 Dirt Bike Leak Oil?
Shop parts for a 2011 Husaberg FE570 Dirt Bike.Is It Really Oil?
Before you start pulling covers, make sure the fluid on your FE570 is actually engine oil. Many riders mistake one fluid for another, and identifying it first can save you hours of chasing the wrong problem. Engine and transmission oil on this liquid-cooled four-stroke is typically amber to dark brown, feels slick between your fingers, and smells like petroleum or burnt oil. Coolant is the main look-alike. It is often green, orange, or pink, feels thinner, and has a distinctly sweet smell. Fork oil is light, clear, and oily with almost no odor, and it usually shows up on the fork tubes rather than around the engine. Brake fluid is thin, slippery, and may look yellowish or clear, and it has a sharp chemical smell. Fuel and premix evaporate quickly and leave a strong gasoline odor with no lasting residue. Taking a moment to match color, smell, and location will tell you which system you are dealing with.
How to Find the Source
Start by degreasing the engine, frame area, and underside of the bike. A clean surface makes fresh oil easy to spot, while old grime hides everything. Next, idle the bike for a few minutes or take a short ride to warm the engine and get oil moving through the seals. Then stop and inspect the bike under good light with a flashlight.
Keep in mind that oil runs downhill and gets blown backward by airflow while you ride. The drip you see on the ground or on the skid plate is often several inches below and behind the real leak. Trace the wet trail upward and forward until you find the highest point of fresh oil.
Wipe suspected areas with a clean rag. Oil that soaks into the rag and leaves a fresh, shiny film is your wettest spot. Dirt sticks to fresh oil, so a grimy, dusty patch with a clean center usually marks the active leak.
Sides of the Engine
The side covers on the FE570 are common sources of seepage, especially after a hard season of enduro riding. The clutch cover gasket is a frequent culprit. Over time it can compress or harden, allowing a slow weep along the cover edge. The ignition or stator cover gasket behaves similarly and tends to leak where it meets the case. If you have a kickstarter, the kickstart shaft seal can also weep oil around its pivot area.
Many side-cover leaks are not caused by a bad gasket at all. Cover bolts that are loose, overtightened, or pinched by a misaligned gasket will push oil out along the seam. Look for oil that collects evenly around the entire cover edge, which often points to a seal or gasket problem, versus a single damp spot, which may point to one bolt that needs attention. Because this bike ages with its owners, gaskets that have spent over a decade in the heat cycle are likely to be stiff and less forgiving.
Under the Bike and Bottom of the Engine
Oil that appears at the bottom of the engine often comes from the drain plug. Check that the plug is snug and that its sealing washer is intact and not flattened or nicked. A washer that has been reused several times is a common reason for a fresh drip after an oil change.
The countershaft seal, located where the front sprocket sits, is one of the most common leak points on dirt bikes. Because it is exposed to mud, grit, and chain spray, oil that leaks past it can run back along the lower case and drip from the sprocket area. Check the sprocket side closely after a ride. The shift shaft seal on the outside of the case can also weep, typically showing oil around the lever shaft.
Rock strikes and hard landings are the usual cause of cracked cases. A crack may seep slowly at first, leaving a thin dark film that gets worse as the engine heats and cools. Any crack in the case is serious, and you should inspect the area carefully after a hard impact on rocky trails.
Top of the Engine and Oil System
Oil on the upper engine often traces back to the valve cover gasket. Look for seepage along the cover edge or around the bolt holes. A base gasket or head gasket can also weep, although these leaks usually show up at the joint between the cylinder and the case or head. Check the external oil lines, banjo bolts, and fittings for wetness, especially where a line enters a fitting. A banjo bolt that is loose or a sealing washer that is worn will leave oil stains that spread down the frame and engine cases.
The oil filter cover is another area to examine. Its O-ring can dry out or get pinched when the cover is reinstalled. A cover that is cross-threaded or overtightened may also seep. After any filter service, check this area with fresh eyes and a clean rag, because a small leak here can be easy to miss.
Oil at the Exhaust
Oil residue on the exhaust pipe or silencer generally means oil is being burned inside the engine. It is not an external leak, and it usually signals that the top end or piston rings need evaluation. Keep an eye on how much smoke you see and whether the oil level drops between services. If you notice this symptom, look at the bigger picture of engine health before assuming the problem is a simple seal.
Oil on the Forks
Oil on the fork tubes, fork guards, or the front brake caliper usually means worn fork seals or dirty dust wipers. Wipe the tubes clean and ride a short distance to see whether the film returns. Cleaning the seals and wipers can sometimes stop a minor weep, but seals that are worn will continue to leak and need replacement.
Fork oil on the front brake is a safety concern. Clean it off thoroughly with brake cleaner before riding, and do not run the bike with contaminated pads or rotor.
Oil on the Rear Shock
An oily film on the shock body, shaft, or linkage area typically means the shock seal is leaking. Wipe the shaft and check whether the oil reappears after a short ride. If it does, the shock will need service, and that work is best handled by a shop with the right tools.
Urgent vs. Can Wait
Some leaks need attention before your next ride. Any fluid on the brakes is an immediate concern. Fast or steady drips from the engine, especially if you see a visible puddle after a short idle, should be addressed before riding. Cracked cases also demand immediate repair or replacement, since a cracked case can fail quickly under load.
Light weeping from a gasket or a thin film on a seal can often be monitored. Clean the area thoroughly, then recheck after a few rides. If the film does not return or stays the same, the leak is likely minor and easy to manage. If it spreads or grows, move it up your repair list.
Prevention
Good habits make leaks much easier to catch early. Inspect covers, seals, and drain plugs after every crash and rock strike, since impacts loosen fasteners and damage gaskets. Keep fork and shock seals clean by wiping the tubes and shaft after muddy rides, which prevents grit from grinding into the seals. After every oil change, check the drain plug, sealing washer, and filter cover for tightness and proper seating. Finally, wash the bike regularly. A clean FE570 makes new leaks obvious, and a fresh drip is far easier to fix when you spot it on day one.
Related Shopping Categories
Shop Oil Seals for a 2011 Husaberg FE570 Dirt Bike.
Shop Gaskets for a 2011 Husaberg FE570 Dirt Bike.
Shop Fork Seals for a 2011 Husaberg FE570 Dirt Bike.
Shop Sealant & Threadlock for a 2011 Husaberg FE570 Dirt Bike.
Shop Skid Plates for a 2011 Husaberg FE570 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.