Fuel Line Replacement on the 2017 Husqvarna TC85BW

Shop parts for a 2017 Husqvarna TC85BW Dirt Bike.

Rubber fuel hose is among the cheapest parts on a 2017 Husqvarna TC85BW and one of the few that can end a ride outright. It hardens, cracks, and weeps fuel where you cannot see it, eventually either starving the engine or putting gasoline somewhere it should never be. Swapping it needs no specialty tools and no shop time.

Symptoms Worth Catching Early

Most failing fuel lines warn you before letting go. The warnings are easy to dismiss, so it helps to know what you are looking at when you walk up to your 2017 Husqvarna TC85BW.

  • A puddle or damp patch underneath. Even a slow weep leaves evidence, usually below the tank or carburetor.
  • A strong fuel smell in the garage. Odor lingering a day after parking is not normal.
  • Visible cracking. Bend the hose gently; fine cracks that open under flex mean the rubber is done.
  • A hose that feels hard or glazed. Healthy line is soft and slightly tacky.
  • Bogging or running lean. A collapsed or deteriorated line restricts flow, and the engine acts like the tank is nearly empty.

Understanding How the Line Deteriorates

The failure is chemical and thermal more than mechanical. Fuel hose stays soft because of additives in the rubber, and those additives leave over time — faster in heat, faster still in the dry air of an arid climate. A hose in that state has lost its ability to seal around a barb, so it seeps before it visibly splits. Fuel left standing does its own damage: ethanol blends draw in moisture and degrade after months of sitting, and the byproducts attack rubber and leave sticky residue. If your 2017 Husqvarna TC85BW winters with fuel in the system, the line ages on the calendar rather than the odometer.

What You Are Working With on the TC85BW

The 2017 Husqvarna TC85BW runs a carbureted fuel system, which works in your favor. Fuel leaves the tank through a petcock — the small valve underneath — travels down a short rubber hose, and enters the carburetor at the float bowl inlet. You can shut fuel off at the source, and the line is a simple two-clamp affair with no pump pressure behind it.

Tools & Preparation

The parts list is short and the tool list shorter. Lay it out before breaking the first connection.

  • Replacement fuel line in the correct inside diameter and length for your 2017 Husqvarna TC85BW. Match the original rather than guessing — oversized line will not seal on the barb.
  • New clamps. Spring clamps lose tension with age, and a small clamp kit costs very little.
  • Nitrile or rubber gloves. Gasoline absorbs through skin.
  • A fuel-safe drain container and a funnel if you plan to reuse the fuel.
  • Pliers and a small flat screwdriver for spring and screw clamps respectively.
  • Shop rags and eye protection.

One genuine safety note: gasoline vapor is heavier than air and travels along the floor toward anything that can ignite it. Work outdoors or with the door open, shut off any heater with a pilot light, keep the fuel container capped, and let a hot engine cool first.

Getting the Old Line Out of the Way

Shut the petcock off first. That single step keeps this job clean on a carbureted TC85BW — with the valve closed, the tank stays full and the only fuel to manage is what is already past the valve.

Empty the carburetor next. Attach a length of clear hose to the float bowl drain nipple, direct it into your container, and open the drain screw. A minute later the bowl is dry and you can work without fuel running down your arm.

With the fuel handled, address the clamps at each end. Squeeze spring clamp tabs together with pliers and walk the clamp down the hose, or loosen a screw clamp with a driver. The hose is usually the hard part: years of heat cycling effectively glue it to the barb. Twist first to break the bond, then pull straight off. When a line is badly hardened, cutting it off with a razor blade is safer for the fitting than prying at it.

Getting the New Line Seated Properly

Measure the replacement against the old line before cutting. Matching the original length keeps routing correct on the TC85BW, and a square cut gives the clamp a clean surface to seal against. Trim with a fresh blade rather than dull side cutters.

Slide the hose fully onto the tank-side fitting, past the barb and up against the shoulder. If the rubber resists, soften it in hot water; do not reach for lubricant. Grease or oil on a fuel fitting shows up later as a slow weep and can carry contamination into the carburetor.

Attach the carburetor end and check the shape of the run. The hose should follow the original path with no contact against cylinder or exhaust and no kink where it curves. Install fresh clamps over the fitting area rather than out on bare hose, and tighten only until the rubber is compressed — a screw clamp cranked down hard will eventually cut through.

Leak Check Before You Ride

Restore fuel flow and watch. Open the petcock on your 2017 Husqvarna TC85BW and leave the bike sitting several minutes with clean cardboard underneath. Gravity finds a poor seal quickly. Look at both fittings with good light, and run a dry fingertip around each joint — fuel is easier to feel than to see.

Then start the engine and check again warm. Vibration and heat expose leaks a static test misses. If you see weeping at a clamp, do not simply crank it tighter; pull the joint apart and confirm the hose was fully seated on the barb, because an unseated hose will not seal at any clamp torque.

Finally, tidy up. Dispose of drained fuel properly rather than returning it to the tank if it looks cloudy or smells stale, and check the new hose after your first ride or two — new rubber takes a small set as it conforms to the fitting. For more background on how fuel quality and storage habits shorten hose life, our full guide to dirt bike fuel line care covers that ground in detail.

Related Shopping Categories

Shop Fuel Lines for a 2017 Husqvarna TC85BW Dirt Bike.

Shop Fuel Line Clamps for a 2017 Husqvarna TC85BW Dirt Bike.

Shop Petcocks for a 2017 Husqvarna TC85BW Dirt Bike.

Shop Fuel Filters for a 2017 Husqvarna TC85BW Dirt Bike.

Shop Fuel Stabilizer for a 2017 Husqvarna TC85BW Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.