Replacing the Fuel Line on a 2007 KTM 50SX Pro Sr.

Shop parts for a 2007 KTM 50SX Pro Sr. Dirt Bike.

A cracked fuel line seems trivial until it strands you at the far end of a trail or drips onto a hot pipe. On a 2007 KTM 50SX Pro Sr., the fuel line is a short, inexpensive piece of rubber doing a job with zero tolerance for failure — and replacing it is well within reach with basic hand tools and about half an hour.

Start by Tracing the Fuel Path

The fuel system on your 2007 KTM 50SX Pro Sr. uses a carburetor, and the petcock is your shutoff. Fuel flows by gravity alone from tank to float bowl through one hose, secured at each end by a spring pinch clamp or a small screw clamp. That is the whole circuit, and it is why this job is beginner-friendly on a two-stroke machine.

Red Flags During a Pre-Ride Look

Fuel line problems show up two ways: something you see and smell, or something you feel while riding. Both are worth taking seriously on a 50SX Pro Sr..

  • Evidence on the ground. A drip or dark patch under the bike after it sits overnight.
  • The smell of raw gasoline. Noticeable with the engine cold and unrun.
  • Surface cracking on the hose. Especially at bends and where the line slides over fittings.
  • Weeping under light pressure. Push gently near a fitting and watch for moisture at the joint.
  • Fuel starvation symptoms. Bogging or cutting out as though the tank ran dry when it clearly has not.

Getting Set Up Before You Start

This is a low-cost job, and most of the preparation is about containing fuel rather than turning wrenches.

  • Replacement fuel line in the correct inside diameter and length for your 2007 KTM 50SX Pro Sr.. Match the original rather than guessing — oversized line will not seal on the barb.
  • New clamps. Spring clamps lose tension with age, and a small clamp kit costs very little.
  • Nitrile or rubber gloves. Gasoline absorbs through skin.
  • A fuel-safe drain container and a funnel if you plan to reuse the fuel.
  • Pliers and a small flat screwdriver for spring and screw clamps respectively.
  • Shop rags and eye protection.

Take the fuel handling seriously. Vapor sinks and spreads, so ventilation matters more than most people assume — work outside or with the door up, and kill any appliance with a standing pilot flame. Keep the drain container closed between pours and wait for the engine to cool.

Understanding How the Line Deteriorates

It helps to treat fuel line as a consumable rather than a permanent part. The material is engineered to stay soft and seal against a barbed fitting, and it loses that ability gradually as heat cycling, sun exposure, and plain calendar age push it the same direction — a dry climate does it fastest. Fuel chemistry compounds the problem. Ethanol blends sitting through a long off-season absorb water and begin to separate, which is harder on rubber than fresh fuel and leaves gum behind. On a 2007 KTM 50SX Pro Sr. stored more than ridden, that combination is the usual culprit.

Removing the Old Fuel Line

Close the petcock. Everything downstream of that valve is the only fuel you need to deal with, which on a 2007 KTM 50SX Pro Sr. amounts to a few ounces in the line and float bowl.

Get that remaining fuel into a container rather than onto the floor. The float bowl drain screw is purpose-built for this — slip a hose over the nipple, aim it into your catch can, and crack the screw open. If you would rather drain the whole tank, do it now with the hose routed into the container.

Then release both clamps and work the hose off the fittings. Pliers handle spring clamps; a flat screwdriver handles screw clamps. Slide each clamp well back so it cannot fight you. To separate a stubborn hose from a barb, rotate it a quarter turn to shear the bond before pulling. If the rubber has gone hard enough that it will not release, split it with a knife along its length — the hose is being replaced anyway, and the fittings are what matter.

Putting the Fresh Hose On

Trim the replacement to the same length as the original. Guessing causes problems at both ends of the range — excess hose finds something hot to lean against, and a short hose loads the fittings every time the engine moves. Cut cleanly and squarely.

Fit the tank-side end first, sliding the hose past the full barb until it bottoms out. If the line is stiff from sitting on a shelf, dip the end in hot water. Do not lubricate: no grease, no oil, no assembly lube on a fuel fitting. Beyond weakening the seal, it introduces contamination into the fuel your 50SX Pro Sr. is about to run.

Connect the carburetor end and look at the whole run before securing anything. The hose should mirror the factory routing with clearance from the exhaust and no kinks. Then set both clamps directly over the barbed sections and tighten just enough to compress the rubber. Over-torquing a screw clamp scores the hose and creates a leak path over time.

Wrapping Up and Checking Your Work

Restore fuel flow and watch. Open the petcock on your 2007 KTM 50SX Pro Sr. and leave the bike sitting several minutes with clean cardboard underneath. Gravity finds a poor seal quickly. Look at both fittings with good light, and run a dry fingertip around each joint — fuel is easier to feel than to see.

Then start the engine and check again warm. Vibration and heat expose leaks a static test misses. If you see weeping at a clamp, do not simply crank it tighter; pull the joint apart and confirm the hose was fully seated on the barb, because an unseated hose will not seal at any clamp torque.

Finally, tidy up. Dispose of drained fuel properly rather than returning it to the tank if it looks cloudy or smells stale, and check the new hose after your first ride or two — new rubber takes a small set as it conforms to the fitting. For more background on how fuel quality and storage habits shorten hose life, our broader walkthrough on dirt bike fuel line replacement covers that ground in detail.

Related Shopping Categories

Shop Fuel Lines for a 2007 KTM 50SX Pro Sr. Dirt Bike.

Shop Fuel Line Clamps for a 2007 KTM 50SX Pro Sr. Dirt Bike.

Shop Petcocks for a 2007 KTM 50SX Pro Sr. Dirt Bike.

Shop Fuel Filters for a 2007 KTM 50SX Pro Sr. Dirt Bike.

Shop Fuel Stabilizer for a 2007 KTM 50SX Pro Sr. Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.