Replacing the Fuel Line on a 2000 KTM 520MXC

Shop parts for a 2000 KTM 520MXC Dirt Bike.

Fuel line replacement sits near the top of the high-value, low-difficulty maintenance list on a 2000 KTM 520MXC. The hose is short, the fittings are simple, and the payoff is a fuel system you can stop worrying about. What follows covers identifying what you have, spotting a line on its way out, and getting the new one leak-free.

What a Dying Fuel Line Looks Like

Fuel line problems show up two ways: something you see and smell, or something you feel while riding. Both are worth taking seriously on a 520MXC.

  • Evidence on the ground. A drip or dark patch under the bike after it sits overnight.
  • The smell of raw gasoline. Noticeable with the engine cold and unrun.
  • Surface cracking on the hose. Especially at bends and where the line slides over fittings.
  • Weeping under light pressure. Push gently near a fitting and watch for moisture at the joint.
  • Fuel starvation symptoms. Bogging or cutting out as though the tank ran dry when it clearly has not.

Why This Part Wears Out at All

The failure is chemical and thermal more than mechanical. Fuel hose stays soft because of additives in the rubber, and those additives leave over time — faster in heat, faster still in the dry air of an arid climate. A hose in that state has lost its ability to seal around a barb, so it seeps before it visibly splits. Fuel left standing does its own damage: ethanol blends draw in moisture and degrade after months of sitting, and the byproducts attack rubber and leave sticky residue. If your 2000 KTM 520MXC winters with fuel in the system, the line ages on the calendar rather than the odometer.

The Carbureted Setup on This 520MXC

The 2000 KTM 520MXC runs a carbureted fuel system, which works in your favor. Fuel leaves the tank through a petcock — the small valve underneath — travels down a short rubber hose, and enters the carburetor at the float bowl inlet. You can shut fuel off at the source, and the line is a simple two-clamp affair with no pump pressure behind it.

Tools & Preparation

Assemble everything first. Once the line is off, you do not want to be driving to the parts store with an open fuel system.

  • Replacement fuel line in the correct inside diameter and length for your 2000 KTM 520MXC. Match the original rather than guessing — oversized line will not seal on the barb.
  • New clamps. Spring clamps lose tension with age, and a small clamp kit costs very little.
  • Nitrile or rubber gloves. Gasoline absorbs through skin.
  • A fuel-safe drain container and a funnel if you plan to reuse the fuel.
  • Pliers and a small flat screwdriver for spring and screw clamps respectively.
  • Shop rags and eye protection.

Take the fuel handling seriously. Vapor sinks and spreads, so ventilation matters more than most people assume — work outside or with the door up, and kill any appliance with a standing pilot flame. Keep the drain container closed between pours and wait for the engine to cool.

Draining Down and Pulling the Line

Turn the petcock to the off position. On the 2000 KTM 520MXC this is the valve underneath the tank, and closing it stops fuel at the source. If your petcock has a reserve position, confirm you are fully off rather than on reserve.

Drain what is trapped downstream. The simplest route is the carburetor float bowl drain — run a short hose from the drain nipple into your container, back the screw out, and let the bowl empty. Snug the screw back up afterward so you do not forget it.

Now free the clamps. Spring clamps come off by squeezing the tabs with pliers and sliding the clamp back along the hose; screw clamps need a few turns of a flat driver. With both retracted, twist the hose on the fitting to break the seal, then work it off. Hardened line often resists — a gentle rotating pull beats brute force, and if it truly will not budge, slit the hose lengthwise with a blade and peel it off rather than levering on the fitting.

Installing the Replacement Hose

Trim the replacement to the same length as the original. Guessing causes problems at both ends of the range — excess hose finds something hot to lean against, and a short hose loads the fittings every time the engine moves. Cut cleanly and squarely.

Fit the tank-side end first, sliding the hose past the full barb until it bottoms out. If the line is stiff from sitting on a shelf, dip the end in hot water. Do not lubricate: no grease, no oil, no assembly lube on a fuel fitting. Beyond weakening the seal, it introduces contamination into the fuel your 520MXC is about to run.

Connect the carburetor end and look at the whole run before securing anything. The hose should mirror the factory routing with clearance from the exhaust and no kinks. Then set both clamps directly over the barbed sections and tighten just enough to compress the rubber. Over-torquing a screw clamp scores the hose and creates a leak path over time.

Leak Check Before You Ride

With the new line in place, open the petcock and stop. Let the 2000 KTM 520MXC sit five minutes over a clean surface and use that time to examine both joints under a flashlight. A properly seated hose stays completely dry; anything else needs attention before the wheels turn.

The running test comes second. Fire the engine, let it warm, and look again — expansion and vibration find seals that hold fine cold and still. When you find a weep, resist the urge to overtighten. Disconnect, verify the hose is pushed fully over the barb, and reassemble; that is nearly always the actual problem.

Wrap up by disposing of the drained fuel appropriately and taking another look at the connections after your next ride. On carbureted bikes an inline filter, if fitted, is a serviceable part worth replacing at the same time. For deeper background on keeping fuel lines healthy between seasons, our full guide to dirt bike fuel line care is a useful companion read.

Related Shopping Categories

Shop Fuel Lines for a 2000 KTM 520MXC Dirt Bike.

Shop Fuel Line Clamps for a 2000 KTM 520MXC Dirt Bike.

Shop Petcocks for a 2000 KTM 520MXC Dirt Bike.

Shop Fuel Filters for a 2000 KTM 520MXC Dirt Bike.

Shop Fuel Stabilizer for a 2000 KTM 520MXC Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.