How to Change the Oil in a 2024 Yamaha YZ250X

Shop parts for a 2024 Yamaha YZ250X Dirt Bike.

Proprietary to MotoSport.com

Tools and Supplies Needed

  • Socket wrench with appropriate metric sockets (commonly 12mm or 13mm for drain bolt)
  • New crush washer (recommended for drain bolt)
  • Oil drain pan
  • Yamaha-recommended transmission oil (gearbox oil) (check manual for type and amount; typically YAMALUBE 2R or equivalent)
  • Measuring cup or oil bottle with volume markings
  • Funnel
  • Gloves and shop rags
  • Torque wrench (recommended)

Important Call-Outs for the 2024 Yamaha YZ250X

  • The YZ250X is a premix two-stroke with a separate, small gearbox/transmission oil system. There is no engine oil filter or oil strainer to service, unlike four-stroke models.
  • You do not change the “engine oil” as with a four-stroke. You are changing the transmission (gearbox) oil, which lubricates the clutch and gears only.
  • The typical gearbox oil capacity is about 0.75 to 0.85 US quarts (0.7-0.8L), but always confirm in your owner's manual for your exact model year.
  • Always use oil meant for two-stroke gearboxes (NOT four-stroke engine oil or automatic transmission fluid). Yamaha recommends Yamalube 2R for mixing fuel and specific transmission oils for the gearbox.

Step-by-Step Guide

  • Warm up the engine. Start your YZ250X and let it run at idle for 1–2 minutes. This helps the oil flow and drain out fully. Then shut off the engine and let it sit for 2–3 minutes to cool slightly for safety.
  • Secure the bike upright. Place your bike on a stand or level ground.
  • Remove the skid plate (if installed). Use your socket wrench to remove the bolts and take off the plate, exposing the bottom of the engine.
  • Locate and remove the transmission/gearbox drain bolt. The bolt is usually under the right or left side of the engine case. Place your drain pan directly under it. Use your wrench to loosen and remove the bolt (be careful as the oil may be hot). Allow oil to fully drain into the pan.
  • Clean and inspect the drain bolt. Wipe away old oil and check the bolt and threads for wear or damage. Replace the crush washer/seal with a new one to avoid leaks.
  • Reinstall the drain bolt. Thread the drain bolt back in by hand, then use a torque wrench to tighten it to the specified value in your owner's manual (typically 10–20 ft-lbs, but verify for the 2024 YZ250X).
  • Remove the oil filler cap. The filler cap is usually on the right engine case. Wipe around the area to prevent debris from entering.
  • Refill with the correct amount of oil. Using your measuring cup or the markings on your oil bottle, pour in the specified amount (usually about 0.75–0.85 US quarts , but double check your owner's manual for the 2024 YZ250X to confirm). Use a funnel for accuracy and avoid spills.
  • Replace the filler cap. Tighten the cap securely.
  • Check for leaks. Wipe down the area around the drain bolt and filler cap, start the engine, and run for 1–2 minutes. Shut off the bike and carefully check for oil leaks.
  • Double-check the oil level. Let the bike sit level for a minute, remove the oil check bolt (if your model has one) or inspect the sight glass (if equipped). Add oil if needed. Do not overfill.
  • Dispose of used oil properly. Take it to a recycling center or auto parts store that accepts waste oil.

Model-Specific Tips for the 2024 YZ250X

  • No oil filter to change. Unlike four-stroke YZ models (YZ250F, YZ450F, YZ250FX), the YZ250X does not have an engine oil filter or external oil strainer.
  • Use the right oil. Only use oil specified for two-stroke gearboxes such as Yamaha Yamalube Trans Oil. The class of oil affects clutch feel and gear life.
  • Confirm drain/level check locations. The design may slightly differ from prior years—check your owner's manual illustrations to identify the correct bolts before starting.
  • Do not confuse gearbox oil change with premix fuel change. The main engine is lubricated by the premix in your fuel, not from engine oil.
  • Routine interval recommendation: Change gearbox oil every 5–10 hours of riding or after muddy/wet conditions for maximum longevity.

Conclusion

Changing the transmission oil in a 2024 Yamaha YZ250X is a straightforward and essential task for maintaining reliable clutch and gear performance. Always use quality oil, replace crush washers, and perform regular changes as recommended by Yamaha for the best results. If you have questions about the process, our MotoSport.com expert support team is happy to help.

Related Shopping Categories

Shop Motor Oil for a 2024 Yamaha YZ250X Dirt Bike.

Shop Oil Filters for a 2024 Yamaha YZ250X Dirt Bike.

Shop Oil Drain Pans for a 2024 Yamaha YZ250X Dirt Bike.

Shop Tools for a 2024 Yamaha YZ250X Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2024 Yamaha YZ250X Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.