How to Change the Oil in a 2014 Husaberg TE250: A Step-by-Step Guide
Shop parts for a 2014 Husaberg TE250 Dirt Bike.
Changing the oil on your 2014 Husaberg TE250 is essential to preserve engine performance and longevity. This guide, created exclusively for MotoSport.com, covers all the tools you’ll need, the steps to take, and specific points to note about this model. Follow this how-to and your TE250 will be ready to ride strong for many more miles.
Tools and Supplies Needed
- Oil Drain Pan
- Measuring Cup (for measuring oil volume)
- Funnel (preferably with a thin stem)
- Ratchet with Quarter Inch Drive
- 8mm Socket
- 13mm Socket (Half Inch Drive)
- Replacement Gear Oil (800ml for the TE250)
- Paper Towels or Shop Rags (for cleaning up spills)
- Protective Gloves
- Optional: Contact Cleaner (cleans up any excess oil)
Specific Call Outs for the 2014 Husaberg TE250
- Oil Capacity:– The TE250 typically takes 800ml of oil–double-check your owner’s manual to confirm
- No Oil Filter:– As a 2-stroke, the TE250 uses gearbox oil only–there’s no engine oil filter to replace
- Drain and Fill Locations:– The drain bolt and oil fill plug are accessible without removing major components
- Warm Engine:– Run the engine for a few minutes and let it cool slightly–warm oil drains faster and more completely
- Check for Leaks:– After changing the oil, always check under the bike for leaks before your next ride
Step-By-Step Oil Change Instructions
-
Warm Up the Engine
Start and let the bike idle for a few minutes. This helps the oil drain more completely. Turn off the engine and let it cool so it’s warm, not hot. -
Stabilize the Bike
Put your Husaberg on a bike stand so it’s upright and level–this is vital for accurate draining and filling. -
Remove the Skid Plate (if equipped)
If your TE250 has a skid plate, remove it to access the drain bolt. -
Prepare Your Tools
Have your drain pan in position under the engine. Get your ratchet set with 8mm and 13mm sockets ready. -
Drain the Old Oil
Use the correct size socket (usually 13mm) to remove the drain plug and let the oil pour into the pan.
Tip:– Lean the bike gently toward you about 30 degrees–this helps drain all oil from low spots in the sump.
Be careful not to lose the crush washer that may be attached to the drain plug. -
Inspect the Drain Plug
Wipe off the drain plug. Inspect for metal shavings–a small amount is normal, but excessive material could mean internal wear. -
Reinstall the Drain Plug
After the oil is fully drained and the area is clean, replace the drain plug (with its crush washer, if fitted) and tighten securely. Don’t over-tighten–refer to your manual for torque specs. -
Add Fresh Oil
Remove the oil fill bolt on the right (clutch) side of the engine. Use a funnel to pour in exactly 800ml of fresh 2-stroke gearbox oil. Avoid spills.
Tip:– It’s easier to pour gradually and check the level through the sight glass, if equipped, or using a measuring cup. -
Check for Leaks and Clean Up
Wipe off any spilled oil from the engine case. Refit the oil fill plug and tighten. Scan for leaks at the drain and fill bolts. -
Dispose of Old Oil Responsibly
Pour the used oil into a suitable container and dispose of it at a recycling center or auto parts store. -
Start the Engine and Double-Check
Start the bike for 1-2 minutes. Shut it off and check for leaks again. Verify the oil level if your model has a sight glass or dipstick. Top up if necessary.
Final Advice for 2014 Husaberg TE250 Owners
- Stick to the 800ml capacity; overfilling can cause shifting issues or leaks
- Change the oil every 10–15 hours of riding, or more often if riding in extreme conditions
- Always check for leaks and ensure the crush washer is replaced as needed
- Double-check your owner’s manual for torque specs and recommended oil types
- Don’t forget to clean your work area, store your tools, and dispose of oil safely
Maintaining your 2014 Husaberg TE250 with regular oil changes ensures smooth shifting, maximum power, and longer life for your gearbox. For more exclusive dirt bike maintenance guides, parts, and tools, trust MotoSport.com—your source for all things off-road.
Related Shopping Categories
Shop Motor Oil for a 2014 Husaberg TE250 Dirt Bike.
Shop Oil Filters for a 2014 Husaberg TE250 Dirt Bike.
Shop Oil Drain Pans for a 2014 Husaberg TE250 Dirt Bike.
Shop Tools for a 2014 Husaberg TE250 Dirt Bike.
Shop Oil Fillers and Drain Plugs for a 2014 Husaberg TE250 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.