How to Change the Oil in a 2009 KTM 105XC

Shop parts for a 2009 KTM 105XC Dirt Bike.

Changing the oil in a 2009 KTM 105XC is a straightforward process that is essential for maintaining the performance and longevity of your motorcycle. Here is a step-by-step guide on how to do it. ### Tools Needed: - Oil drain pan: To catch the old oil as it drains out. - Socket or wrench: For the oil drain plug. Typically a 13 mm socket is used. - T-handle: Optional but makes it easier to remove the drain plug. - Funnel: For pouring in new oil. - New oil filter: If your KTM uses a cartridge-style oil filter. - New oil: Use the type recommended in your owner's manual. - Torque wrench: For tightening the drain plug to the correct specification. - Contact cleaner: For cleaning the magnetic drain plug. - Paper towels: For cleaning up spills. ### Steps to Change the Oil: 1. Warm Up the Engine: Before starting, take your KTM for a short ride to warm up the engine. This helps the oil drain more easily and thoroughly. 2. Position the Bike: Park the bike on level ground. If possible, use a stand to elevate it for better access to the bottom. 3. Remove the Oil Filler Cap: Take off the oil filler cap to allow the oil to drain more quickly when you remove the drain plug. 4. Remove the Drain Plugs: - The main drain plug is usually located at the bottom rear of the engine and is magnetic to catch metal shavings. - There may be a secondary drain plug under the shifter or near the oil filter, depending on the model. Remove both plugs slowly to allow the oil to flow out into the drain pan. 5. Clean the Magnetic Drain Plug: Spray contact cleaner onto the magnetic drain plug to remove any metal debris. This is important for maintaining engine health. 6. Remove and Clean Oil Screens: - If your model has oil screens or filters (other than the oil filter), remove and clean them with a contact cleaner or replace them if necessary. 7. Replace Drain Plugs: Put new crush washers on the drain plugs (if applicable) and tighten them to the recommended torque specification, typically around 20 Nm or 14.8 ft-lb. 8. Refill with New Oil: Use a funnel to pour in the recommended type and amount of new oil. For most KTM four-stroke models, this is about 1.2 liters when changing the oil filter. 9. Replace the Oil Filler Cap: Tighten the oil filler cap securely to prevent leaks. ### Specific Call-Outs for the 2009 KTM 105XC: - Note on Oil Type: Always refer to your owner's manual for the recommended oil type and capacity specific to your model. - Oil Filter: If your model uses an oil filter, ensure you replace it with a new one at each oil change. - Regular Maintenance: Regular oil changes are crucial for maintaining the performance and longevity of your motorcycle. Schedule them according to the manual's recommendations. By following these steps and using the right tools and materials, you can ensure your 2009 KTM 105XC remains in top condition and continues to perform well over time.

Related Shopping Categories

Shop Motor Oil for a 2009 KTM 105XC Dirt Bike.

Shop Oil Filters for a 2009 KTM 105XC Dirt Bike.

Shop Oil Drain Pans for a 2009 KTM 105XC Dirt Bike.

Shop Tools for a 2009 KTM 105XC Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2009 KTM 105XC Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.