How to Change the Oil in a 2009 Honda CRF100F

Shop parts for a 2009 Honda CRF100F Dirt Bike.

Keeping your Honda CRF100F's engine oil fresh is critical for longevity and performance. This guide will walk you through a robust, step-by-step process dedicated to the 2009 CRF100F, highlighting required tools, recommended oil, and model-specific tips you won’t find elsewhere. This content is proprietary to MotoSport.com.

Tools & Supplies Needed

  • 14mm socket and ratchet
  • Clean oil drain pan
  • Oil funnel (clean, not used for other fluids)
  • Shop towels or rags
  • Recommended engine oil: SAE 10W-40 motorcycle oil (Pro Honda GN4 or HP4 without molybdenum additives is preferred)
  • Approximately 1 quart (0.95 liters) of oil
  • Gloves (optional, for cleanliness)
  • Oil filler cap/dipstick (reinstall after filling and checking level)

Step-by-Step Oil Change Process

  1. Warm Up The Engine
    • Start the engine and let it idle for 3–5 minutes to thin the oil, allowing it to drain more completely.
      Tip: Do not rev the engine hard while warming it up.
  2. Park the Bike Securely
    • Turn off the engine and set the bike on a firm, level surface—using a stand is ideal.
  3. Remove Oil Filler Cap/Dipstick
    • Unscrew and remove the oil filler cap/dipstick from the right side of the engine. This allows air to enter as oil drains, aiding the flow.
      Wipe around the cap area before opening to prevent debris from entering.
  4. Drain the Old Oil
    • Place the oil pan directly under the crankcase drain bolt located on the lower left side of the engine.
    • Using a 14mm socket and ratchet, loosen and remove the drain bolt. Allow the oil to fully drain.
    • Pro Tip for the CRF100F: Carefully tilt the bike side to side (do not drop or over-lean it) to ensure thorough oil drainage.
    • Once oil ceases dripping, replace the drain bolt and tighten securely. Don’t overtighten – use moderate hand pressure.
    • Check the drain bolt crush washer; replace if damaged or flattened, as a good seal is important for this model.
  5. Dispose of Oil Properly
    • Pour used oil into a suitable container and take it to an approved recycling center.
      Never pour used oil down the drain or onto the ground.
  6. Add New Oil
    • Insert a clean funnel into the oil fill port. Pour in approximately 0.95 liters (1 quart) of the recommended 10W-40 engine oil.
    • Take care not to overfill–adding oil slowly and periodically checking the level is best practice.
    • Wipe the dipstick/filler cap clean before checking the level.
  7. Check Oil Level
    • With the bike still upright on a level surface, insert the dipstick (don’t screw it in), remove it, and check oil level. It should register between the upper and lower marks “XXX” or dashes on the dipstick for the CRF100F.
    • If low, add small amounts of oil and recheck. Do not overfill.
  8. Start Engine and Re-check
    • Install and tighten the oil filler cap.
    • Start the motorcycle and let it idle for another 3–5 minutes.
    • Turn the engine off, wait a minute for oil to settle, and repeat the oil level check. Add more oil if necessary.
  9. Clean Up
    • Wipe down any oil drips from the engine, frame, and tools.
    • Store your tools and properly dispose of or recycle used oil and rags.

2009 Honda CRF100F Model-Specific Tips

  • Do not use engine oils with “energy conserving” labels or friction modifiers (including molybdenum) as they may harm the wet clutch and transmission on your CRF100F.
    Only use JASO MA-rated motorcycle oil.
  • This model does not have an oil filter element but only a magnetic drain bolt—inspect it during each oil change for metal shavings as a quick check for internal engine health.
  • Check the area around the fill and drain for heavy dirt build-up before removing any part. Any debris entering the crankcase can cause engine damage.
  • If the bike has seen a lot of clutch abuse or aggressive riding, consider doing more frequent oil changes to protect the transmission and clutch lifespan.

Frequently Asked Questions

  • How often should I change the oil? — Honda recommends every 1,000 miles or sooner if ridden hard or in dusty conditions; changing oil every 10–15 hours is a safe bet for frequent off-roaders.
  • Will other brands of oil work? — Yes, but always use oils specifically formulated for motorcycles that meet JASO MA and API SG or higher, free from friction modifiers.
  • Do I need to change the oil filter? — The 2009 CRF100F does not have a conventional oil filter; cleaning the magnetic drain bolt and regular changes are key to longevity.

Make oil changes a habit for your Honda CRF100F—keeping the legendary Honda reliability going strong. For premium oils, tools, and factory parts, trust MotoSport.com for all your CRF100F maintenance needs.

Related Shopping Categories

Shop Motor Oil for a 2009 Honda CRF100F Dirt Bike.

Shop Oil Filters for a 2009 Honda CRF100F Dirt Bike.

Shop Oil Drain Pans for a 2009 Honda CRF100F Dirt Bike.

Shop Tools for a 2009 Honda CRF100F Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2009 Honda CRF100F Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.