How to Change the Oil in a 2007 Honda CRF450X

Shop parts for a 2007 Honda CRF450X Dirt Bike.

Changing the oil in your 2007 Honda CRF450X is an essential part of maintaining performance and longevity. This step-by-step guide, proprietary to MotoSport.com, walks you through the process, detailing the tools, materials, and any important model-specific tips you should know.

Tools & Materials Needed

  • 10mm and 12mm socket or wrench (for drain and oil filter cover bolts)
  • Oil drain pan
  • Rags or shop towels
  • New engine oil (Honda recommends 10W-40; check your owner's manual for oil specs and capacity)
  • Measuring container (750ml for transmission, 1.1L for engine – verify with your manual)
  • New oil filter (engine side filter)
  • Funnel
  • Torque wrench (recommended for re-tightening drain bolts and filter cover)
  • Gloves (optional, for cleanliness)
  • Gasket or O-ring for filter cover (recommended to replace each change)

Preparation

  • Warm up your bike for 1-2 minutes. This thins the oil and helps it drain fully and quickly.
    "You just want to warm up the bike prior to actually draining the oil... this will just reduce the amount of viscosity and thickness of the oil allowing it to drain a lot more easier."
  • Turn the bike off and ensure it is stable, using a stand for safety.

Steps to Change Oil on a 2007 Honda CRF450X

  1. Locate the Drain Bolts
    • The CRF450X uses two distinct oils: engine oil (right side) and transmission oil (left side). Each has a separate drain bolt.
    • Place your oil drain pan beneath the engine oil drain bolt (right side) first.
  2. Remove the Engine Oil Drain Bolt
    • Use your 12mm socket to remove the engine oil drain bolt. Allow oil to fully drain.
  3. Remove the Transmission Oil Drain Bolt
    • Move your drain pan to the transmission side (left) and remove the drain bolt. Let the oil drain completely.
  4. Replace Crush Washers
    • Inspect and replace the crush washers on the drain bolts to prevent leaks.
  5. Reinstall Drain Bolts
    • Once oil has fully drained, reinstall both drain bolts and torque to specification (see your owner's manual for exact values).
  6. Change the Engine Oil Filter
    • On the right side (clutch side), locate the oil filter cover held by two bolts. Remove these with a 10mm socket.
    • Remove old oil filter and O-ring/gasket. Clean the filter cavity.
    • Install the new oil filter, ensuring the correct orientation. Lightly oil the new O-ring for best seal.
    • Reinstall the oil filter cover and torque the bolts evenly to specification.
  7. Add New Oil
    • For the engine side, pour in fresh oil (see owner's manual; usually around 1.1L for engine).
    • For the transmission side, add new oil using a measuring container (generally 750ml is listed, but many recommend filling with up to 1 quart or 950ml for extra protection). Do not overfill.
    • Use the dipstick (engine side) and sight glass or checked bolt (trans side) to verify oil levels are correct.
  8. Final Steps
    • Start the engine and let it idle for a minute. Check for oil leaks at drain plugs and oil filter cover.
    • Stop the engine, let it sit for a couple of minutes, and check oil levels again. Top off if necessary.
    • Safely dispose of old oil and filter according to local regulations.

Model-Specific Call-Outs for the 2007 CRF450X

  • The 2007 CRF450X uses separate engine and transmission oil systems–changing both is crucial for extended reliability.
  • No filter for Transmission Side: Only the engine side has an oil filter to replace; the transmission oil is simply drained and refilled.
    "There's no oil filter or anything like that for the transmission side this just for the engine side pretty much you just want to remove the old filter whenever you're doing an oil change put in the new one."
  • Oil Capacities: Engine oil: approx. 1.1 liters, Transmission: 750ml (manual) or up to 950ml (based on common practice for better protection).
  • Crush Washers: Always inspect and ideally replace the drain bolt crush washers with every oil change to avoid leaks.

Tips and Cautions

  • Never over-tighten drain bolts to prevent stripping the threads.
  • Use only high-quality oil specified for your climate and riding conditions.
  • After changing oil, always monitor for any signs of leakage after first ride.
  • Record your oil change in a maintenance log to keep your CRF450X in top shape.

Performing regular oil changes as outlined above is vital for the health and performance of your 2007 Honda CRF450X. For parts, proper oils, and tools, MotoSport.com offers everything you need to keep your dirt bike ready for the next adventure.

Related Shopping Categories

Shop Motor Oil for a 2007 Honda CRF450X Dirt Bike.

Shop Oil Filters for a 2007 Honda CRF450X Dirt Bike.

Shop Oil Drain Pans for a 2007 Honda CRF450X Dirt Bike.

Shop Tools for a 2007 Honda CRF450X Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2007 Honda CRF450X Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.