How to Change the Oil in a 2006 Honda CRF70F

Shop parts for a 2006 Honda CRF70F Dirt Bike.

Keeping your 2006 Honda CRF70F running smoothly means performing regular maintenance—oil changes being one of the most important. This step-by-step guide, proprietary to MotoSport.com, will walk you through everything you need to change your oil like a pro, including the tools required, precise steps, and essential model-specific tips.

Tools and Supplies Needed

  • 17mm socket or wrench (for drain plug)
  • Oil drain pan
  • Shop rags
  • Funnel
  • Measuring cup (for accurate oil refill)
  • New engine oil (Honda recommends SAE 10W-40 or 10W-30, motorcycle-specific, not automotive)
  • Torque wrench (optional but recommended)
  • Gloves (for clean hands)

Oil Specification and Capacity

  • Recommended type: 4-stroke motorcycle oil, SAE 10W-40 or 10W-30 (Pro Honda HP4S Full Synthetic or Valvoline 4-stroke approved by Honda are popular choices)
  • Capacity: approximately 0.66 US quarts (about 21 fl. oz. or 0.62 liters), but always check oil level per procedure below for accuracy

Important Model-Specific Callouts

  • Correct drain plug location: The oil drain plug is on the right side of the engine, just below the timing gear cover and is a 17mm hex bolt. Do not confuse with the left-side plug that has a spring and peg—it's the internal oil screen access and should not be removed during routine oil changes

    .
  • No oil filter: The CRF70F does not have a replaceable oil filter. It uses an internal oil screen, which is best inspected only during major service.
  • Oil level check: Do not screw in the dipstick when checking oil level. Simply insert it seated and then read the mark

    .

Step-by-Step Oil Change Process

  1. Warm up the engine.
    • Start the bike and let it idle for 3–5 minutes. This thins the oil so it drains out more thoroughly and stirs up any debris.
      Shut off the engine before starting work.
  2. Position the bike and tools.
    • Place the bike upright on a flat, level surface. Use a stand if you have one.
    • Position your drain pan directly under the drain bolt on the right side of the crankcase.
  3. Remove the oil filler cap/dipstick.
    • Unscrew and set the cap aside. This lets the oil drain faster.
  4. Loosen and remove the drain bolt.
    • Use your 17mm wrench or socket. Be careful—the engine may be hot.
    • Let the oil drain completely into the pan. Inspect the oil for any metal shavings or excessive debris, which could signal engine wear.
  5. Reinstall the drain bolt.
    • Tighten by hand, then finish with your wrench. If you have a torque wrench, torque to manufacturer's compression specification (typically around 13 lb-ft / 18 Nm).
    • Wipe any oil drips with a rag.
  6. Fill with new oil.
    • Using a funnel, pour in about 0.66 US quarts (21 ounces) of fresh oil—do not exceed the maximum mark.
    • Insert the dipstick (do not screw in), remove, and check level. Add oil slowly and check frequently to avoid overfilling

      .
  7. Check for leaks and final level.
    • Replace and tighten the filler cap, start the bike, and let it idle for 2–3 minutes.
    • Shut down and wait several minutes to allow oil to settle. Recheck oil level as described above, topping off if needed.
    • Inspect the area around the drain bolt and cap for leaks.
  8. Dispose of the old oil properly.
    • Take the used oil to a recycling facility or auto parts store that accepts waste oil.

Common Questions for CRF70F Oil Changes

  • How often should I change the oil? Every 6 months or 600 miles—whichever comes first—or after heavy riding. Always check more often if the bike is ridden hard or in dirty conditions.
  • Does the bike have an oil filter? No, but it has an internal screen, cleaned only at major service intervals.
  • Can I use synthetic oil? Yes, modern full synthetics like Pro Honda HP4S are approved, but ensure the oil is wet-clutch safe (JASO MA/MA2 rating)

    .
  • What’s the best way to check oil level? Warm engine, let it sit, then insert the dipstick without threading it in. Fill to the upper mark, not above

    .
  • What if I remove the wrong plug? Don’t remove the left side plug with the spring and shaft underneath—it’s for the oil screen, not routine oil changes. Only use the 17mm right-side plug for draining oil

    .

Owner Tips and Reminders

  • Always keep a record of your oil changes—oil, amount, and miles/hours on the bike—to maintain engine warranty and performance.
  • Check for oil leaks after your first ride following the oil change.
  • If you run the bike in dusty or muddy riding, consider changing oil more frequently.
  • When in doubt, consult your 2006 CRF70F owner's manual for official Honda recommendations and diagrams.

Changing the oil in your 2006 Honda CRF70F is straightforward—less than 30 minutes—with basic hand tools and the right oil.

Related Shopping Categories

Shop Motor Oil for a 2006 Honda CRF70F Dirt Bike.

Shop Oil Filters for a 2006 Honda CRF70F Dirt Bike.

Shop Oil Drain Pans for a 2006 Honda CRF70F Dirt Bike.

Shop Tools for a 2006 Honda CRF70F Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2006 Honda CRF70F Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.