How to Change the Coolant in a 2025 GAS GAS MC 65
Routine coolant changes are essential for the 2025 GAS GAS MC 65 to optimize engine temperature and extend component life. This refresh is straightforward, but a few steps are critical to avoid damage and to keep your dirt bike performing at its best.
Preparation
- Let the engine cool completely before starting–never open the radiator system when hot to prevent burns.
- Gather a suitable coolant (consult your owner's manual for recommended types), basic hand tools (socket set, screwdriver, funnel), a drain pan, and rags.
- Work in a well-ventilated space away from children and pets. Coolant is toxic and should never spill into soil or sewage.
Draining the Old Coolant
- Locate the coolant drain bolt at the base of the cylinder or water pump. Position your drain pan beneath.
- Slowly remove the bolt with the appropriate socket and allow coolant to drain fully. Inspect the copper crush washer–if damaged or worn, replace it during reinstallation for a proper seal.
- Clean any residue from the area and threads of the bolt before reinstalling. Torque to manufacturer specifications, usually around 10 Nm (7.4 lb-ft) unless otherwise stated for this model.
Flushing and Filling the Cooling System
- If the system is especially dirty or after heavy muddy use, flush once with distilled water before final filling.
- Remove the radiator cap from the left side of the bike.
- Using a clean funnel, pour in fresh coolant until the level sits just above the radiator fins or the indicated maximum fill line–the MC 65 typically takes between 0.95 liters and 1 US quart of coolant.
- Locate the bleed screw port atop the cylinder head. With the radiator cap off, loosen the bleed screw gently to allow air to escape as you fill. Once steady coolant flows from the port with no bubbles, tighten the screw and top off the coolant if needed.
Finishing Up
- Reinstall the radiator cap firmly.
- Clean any spilled coolant on the frame, engine, or plastics.
- Start the engine and let it run for 2-3 minutes. Carefully inspect for leaks and check the coolant level again, topping off as necessary after any air has purged from the system.
- Dispose of old coolant at a certified recycling facility–never in trash, soil, or drains.
Model-Specific Notes for the 2025 GAS GAS MC 65
- The MC 65 uses a robust two-stroke radiator system similar to the larger MC models, but always check for updated specifications in the latest owner's manual, as recommended fluids or methods may change.
- Fuel tap placement, choke activation, and seat removal are well documented in the 2024-2025 MC 65 owner's guide–reference those sections as needed for easier access around the radiator and cooling system.
- If coolant gets in the eyes or on skin, rinse thoroughly with water and change clothing immediately.
- Never mix coolant types–stick to manufacturer-approved products for best performance and component longevity.
Regular coolant service ensures your 2025 GAS GAS MC 65 runs cool and remains reliable on the track.
Related Shopping Categories
Shop Radiator Hoses for Your Ride
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.