How to Change the Coolant in a 2023 Husqvarna TC250

Shop parts for a 2023 Husqvarna TC250 Dirt Bike.

Routine maintenance is crucial for the performance and longevity of your 2023 Husqvarna TC250, and changing the coolant is one of the most important tasks for keeping your two-stroke engine running cool under pressure. Use this MotoSport guide to perform a complete coolant change at home—tailored specifically for the TC250 model.

Why Change the Coolant?

Coolant degrades over time, reducing its ability to dissipate heat and protect engine components from corrosion. The 2023 TC250, like all modern motocross bikes, uses a liquid-cooling system that demands fresh, high-quality coolant for peak performance. Heat builds quickly during hard riding sessions, so keeping the cooling system fresh ensures consistent race-day power and reliability.

Preparation: Tools & Supplies

  • Fresh coolant compatible with aluminum block engines (consult owner's manual for specifics)
  • Catching pan or container
  • 8mm socket or wrench
  • Funnel
  • Shop towels or rags
  • Protective gloves (optional)

Step 1: Cool the Engine & Secure the Bike

Allow the TC250 engine to cool completely to prevent burns. Place the bike on a stand so that it remains upright and level throughout the process–this ensures all coolant drains properly and makes refilling easier.

Step 2: Remove Radiator Cap

Locate the radiator cap on the left side of the bike, above the radiator. Slowly remove it to relieve pressure in the cooling system before draining. Never remove the cap on a hot engine.

Step 3: Locate & Remove Drain Screw

Place a suitable container under the water pump area—this is where the coolant drains from the 2023 TC250. The drain screw is located on the water pump cover on the right side of the engine. Use your 8mm socket or wrench to carefully remove the drain screw, allowing coolant to fully drain into your catch pan – let it drain until the flow stops completely – then replace and tighten the screw once done – snug, but do not overtighten – it's a small bolt threading into aluminum – so just to factory spec is best – if in doubt, consult the torque values in your owner's manual .

Step 4: Flush the System (Optional, But Recommended)

If changing coolant for the first time or after muddy rides, flushing with distilled water helps remove residues. Fill the radiator with distilled water, reinstall the cap, and briefly start the engine (30–60 seconds, do not overheat). Repeat the drain process. Always finish with a final fill of approved coolant—never run the bike hard on water alone.

Step 5: Refill with Fresh Coolant

With the drain screw tight, use a funnel to pour new coolant into the radiator fill neck until it's just below the lip. The TC250 cooling system is sensitive to air pockets, so fill slowly. If your radiator has a bleeder screw, open it until coolant flows steadily, indicating trapped air has escaped, then re-tighten.

Step 6: Cycle & Top Off

Start the engine and let it idle for a couple minutes with the radiator cap off—this helps work any final air bubbles out. Stop the engine, top off coolant if the level dropped, and finally re-install the cap securely.

Step 7: Inspect and Clean Up

Check for leaks around the drain screw and radiator cap. Dispose of old coolant responsibly—never pour it down the drain or on the ground. Wipe up any spills to avoid environmental harm and slippery surfaces in your garage.

Model-Specific Notes for the 2023 Husqvarna TC250

  • This model features high-performance radiators, so periodic inspection after any tip-over or crash is important. Bent radiator fins or minor leaks will compromise cooling efficiency.
  • Check hoses and clamps for age-related cracking or damage.
  • Factory coolant mixture is optimized for both anti-freeze and anti-corrosion; stick to similar quality for best results.
  • If your TC250 is raced or ridden in extreme conditions, check coolant more frequently than only at scheduled service intervals.

With quality maintenance and the right parts from MotoSport, your 2023 Husqvarna TC250's cooling system will keep your engine running cool and strong, season after season.

Related Shopping Categories

Shop Radiators for a 2023 Husqvarna TC250 Dirt Bike.

Shop Coolant for a 2023 Husqvarna TC250 Dirt Bike.

Shop Temperature Sensors for a 2023 Husqvarna TC250 Dirt Bike.

Shop Tools for a 2023 Husqvarna TC250 Dirt Bike.

Shop Radiator Hoses for a 2023 Husqvarna TC250 Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.