How to Change the Coolant in a 2011 Husqvarna TE310: MotoSport's Guide
Shop parts for a 2011 Husqvarna TE310 Dirt Bike.
Changing the coolant in your 2011 Husqvarna TE310 is essential for optimal performance and preventing engine damage. This step-by-step MotoSport guide ensures a safe and thorough process, specific to the unique features of the TE310.
What Makes the 2011 Husqvarna TE310 Cooling System Unique?
- The TE310 uses a high-efficiency liquid-cooling system, paired with a temperature sensor and a radiator fan that can run even when the ignition is off – be cautious around the fan blades.
- Avoid removing the radiator cap when the engine is hot. Coolant under pressure can spout out, resulting in serious burns.
- Periodically check hoses for cracks, swelling, or brittleness. Aged hoses can cause leaks and possible engine seizure. Tighten all clamps after maintenance.
Tools & Supplies Needed
- New coolant compatible with aluminum radiators (refer to your owner’s manual for specifications)
- Catch pan or vessel for old coolant
- Basic hand tools: socket set, screwdriver, pliers
- Gloves and shop towels
Steps to Change the Coolant
- Prepare the Bike: Place your TE310 on a level surface and ensure the engine is completely cool.
-
Drain the Coolant:
- Locate a vessel on the left side of the cylinder, under the lower radiator hose.
- Loosen the clamp securing the lower hose to the engine and detach the hose. Coolant will begin to flow out – let it drain fully.
- SLOWLY open the right-hand radiator cap to allow air in and ensure complete drainage. Lean the motorcycle to the left if needed.
-
Inspect Hoses and Clamps:
- Check all visible hoses for signs of wear. Replace if cracks, swelling, or hardening are present.
- Inspect the clamps for secure fit.
-
Reconnect Components:
- Reattach the hose to the engine and tighten the clamp securely.
-
Refill with New Coolant:
- Pour the recommended amount of coolant into the radiator. Do not overfill.
- With the radiator cap off, start and idle the engine briefly to help any trapped air escape. Shut off the engine, let it cool, and check the coolant level.
- Top off as necessary, then securely reinstall the radiator cap.
-
Final Checks:
- Warm up the engine fully and verify that the cooling fan activates. Monitor for leaks or overheating.
- After your first ride, let the engine cool and recheck coolant level.
Model-Specific Cautions for TE310 Owners
- Because the cooling fan can run even with ignition off, always keep hands and tools clear when the bike is powered or recently run.
- Never skip scheduled cooling system inspections. The TE310’s high-performance engine relies on precise temperature control – maintaining fresh coolant and hose integrity is essential for longevity.
For all replacement radiators, hoses, clamps, and genuine TE310 parts, MotoSport has you covered with fast shipping and expert support.
Related Shopping Categories
Shop Radiators for a 2011 Husqvarna TE310 Dirt Bike.
Shop Coolant for a 2011 Husqvarna TE310 Dirt Bike.
Shop Temperature Sensors for a 2011 Husqvarna TE310 Dirt Bike.
Shop Tools for a 2011 Husqvarna TE310 Dirt Bike.
Shop Radiator Hoses for a 2011 Husqvarna TE310 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.