Bleeding the Brakes on a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT

Shop parts for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

When This Africa Twin Needs a Brake Bleed

The 2023 Honda Africa Twin 1100 Adventure Sports ES DCT uses hydraulic disc brakes at both ends and is equipped with ABS. The front lever and rear pedal each operate a hydraulic circuit, so a complete bleed means refreshing fluid and removing air from both the front brake and the rear brake. Treat the two circuits as separate service points, and give each one the same careful attention.

A brake bleed is due when the lever or pedal feels spongy, when the lever pulls closer to the grip than it used to, or when the fluid in the reservoir looks dark or cloudy. It is also due after any work that opened the hydraulic system, such as new brake lines, caliper service, or master cylinder work. Even without symptoms, brake fluid absorbs moisture over time. That moisture lowers the fluid’s boiling point and can contribute to brake fade under hard use, so many riders refresh the fluid on a regular schedule. On an Adventure Sports ES DCT that sees loaded touring, gravel-road detours, or repeated hard stops, a soft lever is not something to postpone.

Tools and Supplies to Have Ready

  • Fresh brake fluid of the type marked on the master cylinder reservoir cap, from a sealed container.
  • A box-end wrench that fits the bleeder valve snugly.
  • Clear tubing that fits tightly over the bleeder valve.
  • A catch bottle for used fluid.
  • Rags or shop towels, plus a syringe or turkey baster for removing old fluid from the reservoir.
  • The correct driver for the reservoir cap screws.
  • Optional: a one-way check-valve bleeder or vacuum bleeder to make one-person work easier.

Use only fresh fluid from a sealed container, and discard what has been sitting open. Keep the reservoir cap and diaphragm clean while they are off the bike. A one-way bleeder can reduce the need to coordinate the lever or pedal with the bleeder valve, but the basic squeeze-hold-open-close-release method still works with a helper or with patience.

Prepare the Bike and Protect Sensitive Surfaces

Support the Africa Twin securely upright on a stand so the reservoirs sit as level as possible. Turn the handlebars until the front reservoir is level before you open it. Cover painted surfaces, plastics, and the instrument area with rags, because most brake fluids damage paint and plastic on contact. If a spill happens, wipe it up immediately and rinse the area with water. Keep used fluid away from the bike’s finish and dispose of it properly.

Before opening anything, confirm you can reach the bleeder valve on the caliper you are servicing and that the clear tube will route cleanly into the catch bottle. Keep the reservoir area clean so dirt does not fall into the fluid. Do not let the reservoir run dry at any point during the job; that is the most common way to draw air into a hydraulic brake system.

Bleeding the Front and Rear Brake Circuits

Work on one circuit at a time. The front reservoir is on the handlebar, and the rear reservoir is near the rear master cylinder. Use the same sequence for each circuit, and keep the reservoir topped off throughout.

  1. Remove the reservoir cap and diaphragm. Use a syringe or turkey baster to remove most of the old fluid from the reservoir without letting it run dry.
  2. Refill the reservoir with fresh fluid to the correct level marking.
  3. Fit the clear tube over the bleeder valve on the caliper you are servicing, and route the other end into the catch bottle. Position the box-end wrench on the bleeder valve.
  4. For the front brake, squeeze the lever and hold it steady. For the rear brake, press the pedal and hold it.
  5. Open the bleeder valve about a quarter turn. Fluid and air will move through the tube. Close the bleeder valve before you release the lever or pedal.
  6. Release the lever or pedal slowly. Check the reservoir level and top it off before the next cycle.
  7. Repeat the squeeze-hold-open-close-release sequence until fresh, clean fluid with no bubbles comes through the tube. Keep topping off the reservoir so it never runs low enough to draw air in.
  8. If you are servicing the front calipers, complete one caliper fully before moving to the other. A common general practice is to start with the caliper farthest from the master cylinder, but keep the hose routing clean and the reservoir topped off.
  9. Move to the rear circuit and repeat the process with the pedal. Once the front circuit is complete, reinstall its diaphragm and cap so it stays clean while you work on the rear.
  10. When each circuit runs clean and bubble-free, close the bleeder valve snugly without overtightening.

Because this Africa Twin has ABS, a standard bleed through the caliper bleeders is generally used to refresh fluid. If the reservoir ran dry, or if the ABS unit or its lines were disconnected, air may have entered the ABS unit itself. That situation may require a dealer-level procedure or diagnostic tool, and the bike should go to a shop rather than being forced through a home bleed.

Finishing Up and Testing Before You Ride

Fill each reservoir to the correct level marking, then reinstall the diaphragm and cap. Clean any spilled fluid from the reservoir, caliper, and surrounding surfaces. Check for leaks at the bleeder valve and at the banjo fittings. The lever and pedal should feel firm and consistent, not spongy, and they should not slowly sink under steady pressure. Spin each wheel to confirm the brakes are not dragging. Test the brakes at low speed in a safe area before riding normally.

If the lever or pedal will not firm up after several bleeding attempts, if it firms up only after pumping, if bubbles keep appearing, or if fluid leaks from the master cylinder or caliper, stop and diagnose the problem. Persistent air, a lever that will not hold pressure, or any concern that air entered the ABS unit are reasons to take the 2023 Africa Twin 1100 Adventure Sports ES DCT to a qualified shop. A correct bleed leaves you with a firm, predictable brake feel and clean fluid in both circuits.

Related Shopping Categories

Shop Brake Fluid for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

Shop Brake Lines for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

Shop Brake Pads for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

Shop Stands for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

Shop Brake Tools for a 2023 Honda Africa Twin 1100 Adventure Sports ES DCT Motorcycle.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.