Torque Specs for the 1993 Honda XR200
Shop parts for a 1993 Honda XR200 Dirt Bike.
The 1993 Honda XR200 continues as a proven mid-size trail bike with its 194cc air-cooled OHC four-stroke and five-speed gearbox. The torque specifications are fully consistent with the established XR200 platform. Whether you're completing a seasonal maintenance pass or doing more involved work, these torque values apply directly to the 1993 model.
Engine Torque Values
Cylinder head bolt torque on the 1993 XR200 follows the same cross-pattern sequence as the rest of the lineup. On any XR200 where the engine has been opened, always verify the head torque during reassembly rather than assuming previous work was done correctly.
| Fastener | Torque (ft-lb) | Torque (Nm) |
|---|---|---|
| Spark plug | 13–18 | 18–25 |
| Oil drain bolt | 18–22 | 25–29 |
| Cylinder head bolts | 22–26 | 29–35 |
| Cylinder base bolts | 11–14 | 15–19 |
| Rocker cover bolts | 7–9 | 10–12 |
Wheels & Final Drive
Chain and sprocket maintenance on the 1993 XR200 should be followed by a confirmed torque check on the rear axle nut and chain adjuster lock nuts. The rear axle carries a substantially higher torque requirement than the front due to drivetrain loads.
| Fastener | Torque (ft-lb) | Torque (Nm) |
|---|---|---|
| Front axle nut | 36–44 | 49–59 |
| Rear axle nut | 44–51 | 59–69 |
| Rear sprocket nuts | 29–36 | 39–49 |
| Chain adjuster lock nuts | 11–13 | 15–18 |
Chassis & Suspension Hardware
The swingarm pivot on the 1993 XR200 is the most critical chassis fastener. Its torque value is at the upper end of the range for a mid-size trail bike and requires a 1/2-inch drive torque wrench for accurate application.
| Fastener | Torque (ft-lb) | Torque (Nm) |
|---|---|---|
| Fork clamp bolts | 11–14 | 15–19 |
| Handlebar clamp bolts | 16–20 | 22–27 |
| Swingarm pivot bolt | 51–65 | 69–88 |
| Rear shock upper bolt | 22–26 | 30–35 |
| Rear shock lower bolt | 22–26 | 30–35 |
Tool Guidance
Use a 3/8-inch drive for most of the 1993 XR200's fasteners and a 1/2-inch drive for the swingarm pivot and rear axle nut. Anti-seize on exhaust studs, thread locker on sprocket and shock mount bolts, and dry torque values as the standard baseline.
Related Shopping Categories
Shop Torque Wrenches for a 1993 Honda XR200 Dirt Bike.
Shop Wrenches and Sockets for a 1993 Honda XR200 Dirt Bike.
Shop Thread Locker for a 1993 Honda XR200 Dirt Bike.
Shop Additional Tools for a 1993 Honda XR200 Dirt Bike.
Shop Penetrating Oil for a 1993 Honda XR200 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.
