empty
Shopping CartCLOSE
  • Your cart is empty.
FREE 2-DAY SHIPPING ON ORDERS OVER $49

Hotbodies Racing Motorcycle Fender Eliminators

Most Recent Fender Eliminators Reviews

Hotbodies Racing TAG Fender Eliminator Kit

Hotbodies Racing TAG Fender Eliminator Kit

Cbrguy - Salem, or So so "The product looks pretty decent but horboxies needs to step up the quality control...claims it has all parts but I had to run to the parts store to get the rubber well nuts I was missing from my kit...if you don’t mind that then it’s a decent product"
See all reviews for this product
Hotbodies Racing TAG Fender Eliminator Kit

Hotbodies Racing TAG Fender Eliminator Kit

Sogeking - Houston, TX, USA QA needs some attention. For a 2010 ninja 250. "So the stock mudflap and centerpiece of the tail cover have a barb on each side that splits in half when the mudflap (lower half) and tail cover centerpiece (upper half) are separated. These two halves fit in a grommet/damper and help secure the LH and RH tail covers. This product replace the mudflap and must include the bottom half of the barb, but they merely have a triangular protrusion that does not fit in the grommet. I used some clamping pliers to crush the triangle into a nub approximately the same size as the stock barb. Also, it was missing nuts (the instructions said to use stock bolts and the supplied nuts, but there were none) so I had to run to the hardware store. It did come with a license plate light (a single led hotglued in a hole.) Make sure you put the license plate on before fastening the bracket to your bike. I assumed I'd be able to put it on last and that the holes would be exposed, threaded, or have a threaded well behind them because the instructions show the installation without the license plate, then a "finished" panel with the license plate on. That's not the case and I had to break down the tail end to redo. Once it's on, it's fine. Plenty sturdy. Close gap around my tail light. Less work than fabricating my own, which I only do for my favorites. TL:DR If you get this for an '08-'12 ninja 250, you may have to crush a protrusion on the HB bracket with some pliers to make it fit in the stock grommet. You may have to buy 2 nuts to use with your stock bolts. It has a license plate light."
See all reviews for this product