Swapping the Fuel Line on Your 2018 Suzuki DRZ70
Shop parts for a 2018 Suzuki DRZ70 Dirt Bike.
If you have owned your 2018 Suzuki DRZ70 more than a few seasons, the fuel line deserves a hard look. It is a wear item almost nobody thinks about until it fails, and the failure is rarely graceful. Replacing the hose costs a few dollars, and doing it early beats doing it trailside with a leaking tank.
Start by Tracing the Fuel Path
The fuel system on your 2018 Suzuki DRZ70 uses a carburetor, and the petcock is your shutoff. Fuel flows by gravity alone from tank to float bowl through one hose, secured at each end by a spring pinch clamp or a small screw clamp. That is the whole circuit, and it is why this job is beginner-friendly on a four-stroke machine.
How a Failing Line Announces Itself
A fuel line rarely fails without hinting first. Run through this list before loading the DRZ70 up, particularly if the bike has been sitting.
- Fuel staining at either fitting. Seepage shows up at the barbs before anywhere else.
- Persistent gasoline smell. If you smell fuel with the bike cold and untouched, something is leaking.
- Cracks that appear when you flex the hose. Dry rot hides at rest and reveals itself the moment rubber bends.
- Swelling or a soft, mushy section. The opposite of hardening and just as bad — usually chemical attack.
- Surging or dying under load. Restricted flow mimics fuel starvation and gets misdiagnosed as a jetting problem.
Tools & Preparation
The parts list is short and the tool list shorter. Lay it out before breaking the first connection.
- Replacement fuel line in the correct inside diameter and length for your 2018 Suzuki DRZ70. Match the original rather than guessing — oversized line will not seal on the barb.
- New clamps. Spring clamps lose tension with age, and a small clamp kit costs very little.
- Nitrile or rubber gloves. Gasoline absorbs through skin.
- A fuel-safe drain container and a funnel if you plan to reuse the fuel.
- Pliers and a small flat screwdriver for spring and screw clamps respectively.
- Shop rags and eye protection.
One genuine safety note: gasoline vapor is heavier than air and travels along the floor toward anything that can ignite it. Work outdoors or with the door open, shut off any heater with a pilot light, keep the fuel container capped, and let a hot engine cool first.
Why This Part Wears Out at All
Rubber fuel line fails for reasons that have little to do with how hard you ride. Age drives it: the plasticizers keeping the hose flexible slowly migrate out, and pliable rubber turns stiff and glassy, so a small flex — bolting the tank down, rocking the bike onto a stand — opens a hairline crack. Dry, hot storage accelerates that, pulling volatiles out faster than a temperate garage would. Ethanol-blended pump fuel left sitting in the hose adds a second mechanism, attacking the inner wall and leaving gum that can flake into the fuel path on a 2018 Suzuki DRZ70.
Removing the Old Fuel Line
Turn the petcock to the off position. On the 2018 Suzuki DRZ70 this is the valve underneath the tank, and closing it stops fuel at the source. If your petcock has a reserve position, confirm you are fully off rather than on reserve.
Drain what is trapped downstream. The simplest route is the carburetor float bowl drain — run a short hose from the drain nipple into your container, back the screw out, and let the bowl empty. Snug the screw back up afterward so you do not forget it.
Now free the clamps. Spring clamps come off by squeezing the tabs with pliers and sliding the clamp back along the hose; screw clamps need a few turns of a flat driver. With both retracted, twist the hose on the fitting to break the seal, then work it off. Hardened line often resists — a gentle rotating pull beats brute force, and if it truly will not budge, slit the hose lengthwise with a blade and peel it off rather than levering on the fitting.
Putting the Fresh Hose On
Cut the new hose to length using the old one as a template, adding nothing extra. Line that is too long sags into the engine or gets pinched when the tank is bolted down; too short and it tugs at the fittings under vibration. A clean square cut seals better than a ragged one.
Push the new line onto the petcock spigot first, far enough to cover the full barb. Stiff hose goes on more easily after thirty seconds in warm water. What you must not do is lubricate the fitting — no grease, no oil, no silicone. Any of it compromises the seal and can contaminate the fuel path on your 2018 Suzuki DRZ70.
Position the carburetor end next, checking your routing against how the original sat. Then set the clamps over the barb area, about a quarter inch from the hose end, so they compress rubber against the raised portion of the fitting. Snug is the target with screw clamps, not tight — overtightening cuts into the hose and creates the leak you were preventing.
Confirming It Is Sealed
Open the fuel valve and let gravity do the testing. Give the DRZ70 a few minutes standing over clean cardboard, then inspect the tank-side and carburetor-side joints carefully. Wipe each dry first so new moisture is unmistakable.
Follow that with a running check. Start the engine, bring it to temperature, and look at both fittings again at idle — some leaks only appear once heat and vibration are in the system. A joint weeping under those conditions has a seating problem, not a clamp problem; pull it apart and push the hose fully home.
Then clean up and stay attentive for a ride or two. Dispose of old fuel properly, watch the clamps as the new rubber settles, and consider replacing an inline filter while the system is open. Anyone wanting more detail on what shortens fuel line life long term will find it in our broader walkthrough on dirt bike fuel line replacement.
Related Shopping Categories
Shop Fuel Lines for a 2018 Suzuki DRZ70 Dirt Bike.
Shop Fuel Line Clamps for a 2018 Suzuki DRZ70 Dirt Bike.
Shop Petcocks for a 2018 Suzuki DRZ70 Dirt Bike.
Shop Fuel Filters for a 2018 Suzuki DRZ70 Dirt Bike.
Shop Fuel Stabilizer for a 2018 Suzuki DRZ70 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.