How to Change the Oil in a 2019 KTM 350XCF: Step-by-Step Guide

Shop 2019 KTM 350XCF Dirt Bike OEM Parts now.

Changing the oil in your 2019 KTM 350XCF is an essential maintenance task to keep your bike performing at its best. Below is a comprehensive guide proprietary to MotoSport.com, detailing the process, tools needed, and specific insights relevant to this model.

Tools & Materials Needed

  • Metric socket or spanner set (13mm for drain plug and oil screen bolt)
  • Oil drain pan
  • New engine oil (approximately 1 liter of 10W-50; check your oil spec and quantity in the owner's manual)
  • New oil filter
  • Replacement copper crush washer (for drain plug)
  • Replacement O-ring (for oil screen bolt, inspect the old one for damage)
  • Paper towels or shop rags
  • Funnel
  • Contact cleaner (for cleaning up spills and oily parts)
  • Grease (optional, for sealing O-rings)
  • Measuring cup (for precise oil fill)

Step-by-Step Oil Change Procedure

  • Warm Up the Engine
    • Start the bike and let it idle for a few minutes to warm the oil. Warm oil drains more easily and carries impurities away.
  • Remove Skid Plate (if equipped)
    • Use appropriate tools to remove the factory skid plate for better access to the drain plug and oil screen if your bike has one installed.
      2019 KTM 350XCF owners frequently note this is necessary due to the tight fit around the drain bolts.
  • Place Drain Pan and Remove Drain Plug
    • Position your oil pan under the engine. The main oil drain plug is 13mm, located at the bottom of the crankcase.
    • Carefully remove the plug and copper crush washer. Inspect washer and replace if damaged to avoid leaks.
    • Let all oil drain out.
    • Call-out: This plug is magnetic and may have fine metallic particles on it, especially after recent engine work or initial break-in. Wipe it clean.
  • Remove and Clean Oil Screen Filter
    • Locate the oil screen bolt (also 13mm) on the side or front of the engine. Remove this bolt to extract the oil screen.
    • Inspect the screen for debris and carefully clean it with contact cleaner. Replace or clean the O-ring; ensure it's not damaged.
    • Reinstall the screen and bolt once clean and dry.
  • Replace the Oil Filter
    • The oil filter cover is usually held in place with two bolts. Remove the cover, take out the old filter, and inspect the cavity for debris.
    • Install the new filter, ensuring it seats properly. Lubricate any O-rings with a small amount of grease if desired for better sealing.
    • Reinstall the oil filter cover and tighten the bolts to the manufacturer's recommend

      Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.