How to Change the Oil in a 2016 KAWASAKI KLX110 – The Complete MotoSport.com Guide

Shop parts for a 2016 KAWASAKI KLX110 Dirt Bike.

Regular oil changes are essential to keep your 2016 Kawasaki KLX110 running at its best. A clean, fresh supply of oil ensures smooth engine operation and maximizes the lifespan of internal components. This how-to guide from MotoSport.com will walk you through every step, calling out KLX110-specific notes you need to know. Even if you’re new to bike maintenance, you’ll be able to tackle this job with confidence.

Tools and Supplies You’ll Need

  • 3/8-inch ratchet and extension
  • 8mm, 12mm, and 17mm sockets
  • Torque wrench (for proper tightening)
  • Oil drain pan
  • Clean rags
  • 1 liter of 10W-40 motorcycle oil (0.9 liters if not replacing filter)
  • New oil filter (if changing the filter)
  • Gloves (optional for keeping hands clean)

Preparation Steps

  • Warm up the engine for a few minutes. This helps thin the oil so it drains better, as well as circulates contaminants for removal. But be careful—the exhaust and engine will be hot after running.
  • Turn off the bike and make sure it’s upright on a level surface.
  • Have all your supplies ready and within reach.

Steps to Change the Oil on Your 2016 Kawasaki KLX110

  • Remove the skid plate:
    • Loosen and remove the 8mm bolts on each side of the skid plate.
    • Remove the two 12mm bolts located behind the skid plate.
    • Take off the skid plate and set it aside.
    • Model note: Be cautious of hot exhaust parts if the engine was recently run.
  • Open the oil fill cap:
    • Unscrew the oil cap on top of the engine. This allows air in for a smoother, faster drain.
  • Drain the old oil:
    • Position an oil drain pan directly beneath the engine.
    • Use a 17mm socket to remove the drain bolt on the underside of the engine.
    • Allow all the oil to flow out. Dispose of used oil properly through a recycling center or auto shop.
  • (Optional) Change the oil filter:
    • If you’re also replacing the filter (recommended every few oil changes), remove and replace it now. The KLX110 filter can be accessed after removing the cover, using the appropriate tools.
  • Reinstall the drain bolt:
    • Clean the drain bolt and check its washer or seal. Replace if damaged.
    • Thread it in by hand, then snug it securely with your ratchet. If using a torque wrench, tighten to factory specs (typically about 18 ft-lb, but verify your manual).
  • Pour in new oil:
    • Place a funnel in the oil fill hole.
    • Fill with 0.9 liters (if NOT changing the filter) or 1.0 liter (if changing the filter) of 10W-40 motorcycle oil.
    • Let the oil settle for a minute.
  • Check oil level:
    • Reinstall the oil fill cap. Start the bike and let it idle for 2–3 minutes.
    • Shut off the engine and wait 1–2 minutes for the oil to drain back into the case.
    • Check the oil level through the sight glass located on the side of the crankcase. The level should be between the upper and lower marks.
    • If needed, add or remove oil until it’s in the correct range.
  • Reassemble and final check:
    • Wipe up any drips on the engine.
    • Reinstall the skid plate using the 8mm and 12mm bolts.
    • Always visually check for leaks under the bike after the first ride.

2016 Kawasaki KLX110-Specific Tips

  • Oil capacity: 0.9 liters without filter change, 1.0 liter with filter change—do not overfill, which can cause excessive pressure or leaks.
  • Check the sight glass while the bike is upright and level for accurate readings.
  • Skid plate removal is required for oil changes on this model; replace all hardware securely to prevent rattling or loss.
  • Warm oil drains better but be cautious—exhaust gets hot fast.
  • Use only motorcycle-specific oil; automotive oils can cause clutch problems.

Final Thoughts from MotoSport.com

Changing your 2016 Kawasaki KLX110’s oil can be done quickly at home and goes a long way in protecting your engine. By following these model-specific instructions and using the right tools, you’ll help your bike run optimally for many rides to come. If you need top-quality oil, filters, or tools, MotoSport.com has you covered—your one-stop dirt bike parts and maintenance shop.

Related Shopping Categories

Shop Motor Oil for a 2016 KAWASAKI KLX110 Dirt Bike.

Shop Oil Filters for a 2016 KAWASAKI KLX110 Dirt Bike.

Shop Oil Drain Pans for a 2016 KAWASAKI KLX110 Dirt Bike.

Shop Tools for a 2016 KAWASAKI KLX110 Dirt Bike.

Shop Oil Fillers and Drain Plugs for a 2016 KAWASAKI KLX110 Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.