How to Change the Oil in a 2016 Beta 250 RR Race
Shop parts for a 2016 Beta 250 RR Race Dirt Bike!
Maintaining the transmission oil in your 2016 Beta 250 RR Race is essential for peak performance, smooth shifting, and extended engine life. The Race Edition models are premix only (no oil injection) and require a simple oil change process that any rider can master. Below is a proprietary MotoSport guide to keep your championship-ready Beta running strong.
What Makes the 2016 Beta 250 RR Race Unique?
- No oil injection system – owners must premix their fuel, and the oil change procedure focuses on the transmission case only. Use a proper premix ratio for engine lubrication.
- Optimized for performance – race-tuned engine and transmission components benefit greatly from fresh, high-quality oil at recommended change intervals.
- Transmission oil type – Beta recommends a 10W40 gear/transmission oil, such as Motul Transoil Expert 10W40, for optimal gear protection and clutch function*.
Tools & Supplies Needed
- 13mm socket or T-handle
- Drain pan
- Funnel
- Contact cleaner and rag
- New transmission oil (Motul Transoil Expert 10W40 or equivalent, capacity 800cc/0.8L)
- Gloves
Step-by-Step Oil Change Instructions
- Warm up the engine: Run your Beta for a few minutes to thin the oil – this helps debris drain out with the old oil.
- Stabilize the bike: Place your bike upright on a stand or securely on level ground.
- Remove the skid plate if equipped, for easier access to the drain bolt.
- Locate the drain bolt: The transmission drain bolt is on the bottom of the engine case. Use your 13mm socket to remove it, letting the oil drain fully into your pan.
- Open the filler cap: Loosen and remove the oil filler cap on the side case – this allows oil to flow out and air to enter.
- Inspect and clean the drain plug: The plug will usually have a magnet to collect metal particles*. Wipe it clean with your rag and contact cleaner. The plug uses an O-ring seal, so inspect and replace if worn.
- Reinstall the drain plug: Once fully drained, reinstall the plug and hand-tighten, then snug with the socket – do not overtighten.
- Add new transmission oil: Using a funnel, carefully pour in 800cc (0.8L) of fresh oil. This is optimal for the 2016 250 RR Race*.
- Check oil level: With the bike level, use the site glass or oil level bolt (if equipped) to verify the correct oil level. Add or remove oil as necessary.
- Reinstall filler cap and skid plate (if removed).
- Clean up: Wipe away any spills and verify there are no leaks at the drain or filler caps.
- Record your maintenance: Log the oil change and engine hours in your maintenance journal, aiming to change transmission oil every 8–10 hours of riding or after extreme conditions*.
Pro Tips for Beta 250 RR Race Owners
- Premix your fuel using high-quality 2T oil, such as Motul 800 2T, at the ratio specified in your owner's manual.
- Watch for transmission oil contamination – milky oil indicates water ingress and requires immediate attention.
- The magnetic drain plug helps extend gear life by trapping wear particles – keeping it clean at oil changes maximizes its effectiveness.
- If your O-ring shows signs of damage or excessive flattening, replace it with each oil change to prevent leaks.
Keep your 2016 Beta 250 RR Race running at its best by following this MotoSport oil change guide every time.
*Technical specifications confirmed from the 2016 Beta 250 RR Race owner's manual and real-world owner procedures.
Related Shopping Categories
Shop Motor Oil for a 2016 Beta 250 RR Race Dirt Bike!
Shop Oil Filters for a 2016 Beta 250 RR Race Dirt Bike!
Shop Oil Drain Pans for a 2016 Beta 250 RR Race Dirt Bike!
Shop Tools for a 2016 Beta 250 RR Race Dirt Bike!
Shop Oil Fillers and Drain Plugs for a 2016 Beta 250 RR Race Dirt Bike!
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.