Only issue I have I the stickers on the plastic shields. They came off within the 1st 2 weeks, which hurts the look of the product.
They look great on and although i haven't gone down to test them i am sure they work great but the install was a bit tough seams as though they are not bent the same the clutch side needed a little tweak to get it to fit up but the throttle side i had to clamp it to a bench and just about rebend the damm thing to get it to fit up and putting on the plastic was a bit of a pain in the booty good thing i had extra screws of my own
great hand guards, very well made i have already hit a couple trees with them and hey hold up great would definetly recommend to anyone else
Graphics were not stuck to hand guards before I even took them out of the package. I went ahead and put them on anyway and pressed the graphics back down thinking they would stay but did not. Now I just have plain looking white guards. Have sent 2 emails to cycra customer service and have not heard anything back. Guess I will call now.
Quality parts that go on easily. Only suggestion... put some WD40 in thread before you screw in the screws. They are so tight that you think you're crossthreaded or you are going to strip the screw head. Looks great on the bike and you can tell they're going to do their job.
These fit great and are probably the best protection you can get for your hands and controls.
A great addition to my bike, built very well, haven't rode since I put them on but should last a very long time
They prob would have been a four star but they didn't match up with my handle bars at all. But alot of the hardware didn't work like it was suppose to. Like the pieces that go in the end of your bars didn't tighten down like they were suppose to and screws for actually plastics were stripping out just trying to tighten them down. Not even using alot of strength