The Regent-X is a brand-new helmet from Arai. It has a fresh, aggressive style unique in the range and is designed to welcome riders to the Arai family with the plush comfort, protection and features expected of the brand but also something else - easy access on and off.
Like every Arai, the Regent-X uses a strong outer shell designed to glance off impact forces, while maintaining integrity, working with a softer one-piece multi-density EPS inner liner to absorb and spread impact energy. It's designed around the Variable Axis System (VAS) for a smoother shape plus reinforcing Hyper Ridge that lowers the center of gravity and flares out 5 mm to make putting it on or off easier.
It's equipped with dual intake vents, brow vents and a three-way chin vent plus five exhausts. The VAS-V MAX vision visor is Pinlock ready (insert sold separately) and uses Arai's F1-derived latch mechanism; the semi-removable interior features Facial Contour System (FCS) and speaker pockets. The optional (sold separately) Pro Shade System (PSS) can be equipped. The Arai experience starts here.
The Regent-X shell uses the newly developed PBcLc1 shell. Lower cost without compromising weight or performance.
Expanded Hyper-Ridge, in the chin and cheek area by 5 mm.
Enlarging only the bottom opening for easier on/off without making the helmet bigger.
Same legendary Arai fit, just made easier to get on and off.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.