Clampless Starting Harness

• Product Details

  The Clampless Starting Harness connects directly to your battery, so you can easily Jump-Start or Energize your vehicle without using the MICRO-START clamps. Saves time with no need to remove the motorcycle seat, open the car hood, or even touch the battery.

  • Choose length: 16 inches, 20 inches, or 45 inches.
  • Ring terminals connect directly to your battery.
  • Other end plugs into the Micro-Start's jumpstart port.
  • 16 or 20-inch Harness is great for motorcycles.
  • 45-inch Harness is best for cars and trucks.

  The MICRO-START Clampless Harness was made so a rider or driver can easily jump-start or energize their vehicle using just their Micro-Start. No need for jumper clamps, removing the motorcycle seat, or opening your car hood or trunk. The Harness makes for quick and easy energizing to get into the vehicle, or to jump-start your ride, without having to access the battery itself.

  Using the Harness:

  The wire harness has ring terminals that connect directly to the battery, while its other end can be tucked away for easy access, to plug into the Micro-Starts (or similar products) Jump-Start port. It adds convenience and saves time if the situation arises when your vehicle needs a jump. Simply connect the Micro-Start directly to this harness and jump-start your vehicle. No need to get out your Micro-Start clamps or even touch the battery!

  Longer Harness for Automobiles:

  The 20-inch Clampless Harness is a good length for use in motorcycles. They also offer a longer 45-inch version for use in cars or trucks. It allows the user to route it to an area of the car so a jump-start or energizing of the car can be done without opening the hood or trunk. For example many of todays cars will completely shut down without battery power, and you cannot even open the hood or trunk if your battery goes dead. But you could route the Harness to an area just outside the vehicles trunk or hood area, and in the event you come back to a dead battery simply plug in a Micro-Start (or other similar product) to energize the vehicle and open the hood or trunk to access the battery, or just jump-start the vehicle without opening the hood.

  The Harness takes only minutes to install and at 45 is usually enough length to route to an area outside your car for easy access when needed.

  Notes: A standard Battery Tender type harness WILL NOT handle jump-starting; the wire gauge is much too thin and it will melt the wires. The Micro-Start is for jump-starting only through the jump start port! Never leave the Micro-Start connected to your vehicle's battery or use in place of your regular battery! Do NOT try to charge the Micro-Start directly from your battery through the jump start port - severe damage can result! The MICRO-START should be removed from this Harness once the car is started or energized. Do NOT leave the MICRO-START connected for more than 3 minutes when Energizing, over discharge may occur to MICRO-START. Do NOT leave MICRO-START connected more than 90 seconds after a jump start, back charge and damage to MICRO-START may occur.

  Report Incorrect Product Information

  ---

  Read More

• Customer Reviews

• Q&A

• # Part Numbers

  Product Variant	Manufacturer Part #
  For XP10Gen1 And XP10HD / 16in	AG-MSA-10B
  For XP1Gen2 and XP10Gen2 / 20in	AG-MSA-10D
  For XP1Gen2 and XP10Gen2 / 45in	AG-MSA-10D-L
  For XP20 and XP20HD / 20in	AG-MSA-10C
  For XP20 and XP20HD / 45in	AG-MSA-10C-L

Find More