What Size Chain Does My 2000 Husaberg FE600 Dirt Bike Use?
Shop dirt bike parts for a 2000 Husaberg FE600 Dirt Bike.
What Chain Size Does the 2000 Husaberg FE600 Use?
The 2000 Husaberg FE600 typically uses a 520 chain size as its OEM specification. This is the most common size for this model and year, designed to handle the power and torque of the FE600's large displacement engine. While most 2000 FE600s use a 520 chain, it's important to note that some bikes may have been modified with aftermarket sprockets or custom setups, which could require a different chain size. If you're unsure, always verify by checking your current chain or consulting your owner's manual.Understanding Dirt Bike Chain Sizes
The "520" in a 520 chain refers to two key measurements:- Pitch: The distance between the centers of two adjacent pins, measured in eighths of an inch. For a 520 chain, the pitch is 5/8 inch.
- Width: The internal width between the inner plates, measured in eighths of an inch. For a 520 chain, the width is 2/8 inch (or 1/4 inch).
How Many Links Does the Chain Have?
The typical OEM chain for the 2000 Husaberg FE600 comes with approximately 118 links. However, this number can vary depending on:- Sprocket changes: Installing larger or smaller sprockets will require adding or removing links to maintain proper chain tension.
- Axle position: Adjusting the rear axle for chain tension or wheelbase can affect the required link count.
- Wheelbase adjustments: Modifications to the swingarm or rear wheel position may also change the ideal chain length.
Factors That Can Affect Chain Size or Length
Several factors can influence the correct chain size or length for your 2000 Husaberg FE600:- Riding type: Motocross, trail, or enduro riding may require different sprocket setups, impacting chain length.
- Engine displacement and torque: The FE600's powerful engine demands a robust chain, making the 520 size ideal.
- Aftermarket sprockets: Upgrading to different tooth counts can require a longer or shorter chain.
- Suspension setup: Changes to suspension geometry or travel can affect chain slack and length requirements.
How to Confirm the Correct Chain for Your Bike
To ensure you get the right chain for your 2000 Husaberg FE600, follow these steps:- Check the markings on your existing chain for size information (e.g., "520").
- Count the number of links on your current chain to match the length.
- Reference your owner's manual for OEM specifications.
- If in doubt, measure the pitch (distance between pins) and width (between inner plates) to confirm the chain size.
When Should You Replace Your Chain?
Replace your chain if you notice:- Excessive stretching or kinking
- Visible wear on the rollers or side plates
- Difficulty maintaining proper tension
- Noticeable "shark fin" wear on sprocket teeth
Related Shopping Categories
Shop Chains for a 2000 Husaberg FE600 Dirt Bike.
Shop Suspension Oil for a 2000 Husaberg FE600 Dirt Bike.
Shop Chain and Sprocket Kits for a 2000 Husaberg FE600 Dirt Bike.
Shop Chain Cleaners for a 2000 Husaberg FE600 Dirt Bike.
Shop Chain Lubricant for a 2000 Husaberg FE600 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.
