Getting a Fresh Fuel Line Onto Your 2017 Cobra CX50FWE

Shop parts for a 2017 Cobra CX50FWE Dirt Bike.

If you have owned your 2017 Cobra CX50FWE more than a few seasons, the fuel line deserves a hard look. It is a wear item almost nobody thinks about until it fails, and the failure is rarely graceful. Replacing the hose costs a few dollars, and doing it early beats doing it trailside with a leaking tank.

Start by Tracing the Fuel Path

The 2017 Cobra CX50FWE runs a carbureted fuel system, which works in your favor. Fuel leaves the tank through a petcock — the small valve underneath — travels down a short rubber hose, and enters the carburetor at the float bowl inlet. You can shut fuel off at the source, and the line is a simple two-clamp affair with no pump pressure behind it.

How a Failing Line Announces Itself

Most failing fuel lines warn you before letting go. The warnings are easy to dismiss, so it helps to know what you are looking at when you walk up to your 2017 Cobra CX50FWE.

  • A puddle or damp patch underneath. Even a slow weep leaves evidence, usually below the tank or carburetor.
  • A strong fuel smell in the garage. Odor lingering a day after parking is not normal.
  • Visible cracking. Bend the hose gently; fine cracks that open under flex mean the rubber is done.
  • A hose that feels hard or glazed. Healthy line is soft and slightly tacky.
  • Bogging or running lean. A collapsed or deteriorated line restricts flow, and the engine acts like the tank is nearly empty.

Why This Part Wears Out at All

The failure is chemical and thermal more than mechanical. Fuel hose stays soft because of additives in the rubber, and those additives leave over time — faster in heat, faster still in the dry air of an arid climate. A hose in that state has lost its ability to seal around a barb, so it seeps before it visibly splits. Fuel left standing does its own damage: ethanol blends draw in moisture and degrade after months of sitting, and the byproducts attack rubber and leave sticky residue. If your 2017 Cobra CX50FWE winters with fuel in the system, the line ages on the calendar rather than the odometer.

Tools & Preparation

Assemble everything first. Once the line is off, you do not want to be driving to the parts store with an open fuel system.

  • Replacement fuel line in the correct inside diameter and length for your 2017 Cobra CX50FWE. Match the original rather than guessing — oversized line will not seal on the barb.
  • New clamps. Spring clamps lose tension with age, and a small clamp kit costs very little.
  • Nitrile or rubber gloves. Gasoline absorbs through skin.
  • A fuel-safe drain container and a funnel if you plan to reuse the fuel.
  • Pliers and a small flat screwdriver for spring and screw clamps respectively.
  • Shop rags and eye protection.

Before the first fitting comes loose, handle the safety side. Gasoline vapor pools low and finds ignition sources you would never consider, including pilot lights across the room. Ventilate properly, keep fuel in a closed container, wear eye protection, and never open the system on a hot engine.

Draining Down and Pulling the Line

Shut the petcock off first. That single step keeps this job clean on a carbureted CX50FWE — with the valve closed, the tank stays full and the only fuel to manage is what is already past the valve.

Empty the carburetor next. Attach a length of clear hose to the float bowl drain nipple, direct it into your container, and open the drain screw. A minute later the bowl is dry and you can work without fuel running down your arm.

With the fuel handled, address the clamps at each end. Squeeze spring clamp tabs together with pliers and walk the clamp down the hose, or loosen a screw clamp with a driver. The hose is usually the hard part: years of heat cycling effectively glue it to the barb. Twist first to break the bond, then pull straight off. When a line is badly hardened, cutting it off with a razor blade is safer for the fitting than prying at it.

Putting the Fresh Hose On

Trim the replacement to the same length as the original. Guessing causes problems at both ends of the range — excess hose finds something hot to lean against, and a short hose loads the fittings every time the engine moves. Cut cleanly and squarely.

Fit the tank-side end first, sliding the hose past the full barb until it bottoms out. If the line is stiff from sitting on a shelf, dip the end in hot water. Do not lubricate: no grease, no oil, no assembly lube on a fuel fitting. Beyond weakening the seal, it introduces contamination into the fuel your CX50FWE is about to run.

Connect the carburetor end and look at the whole run before securing anything. The hose should mirror the factory routing with clearance from the exhaust and no kinks. Then set both clamps directly over the barbed sections and tighten just enough to compress the rubber. Over-torquing a screw clamp scores the hose and creates a leak path over time.

Confirming It Is Sealed

Restore fuel flow and watch. Open the petcock on your 2017 Cobra CX50FWE and leave the bike sitting several minutes with clean cardboard underneath. Gravity finds a poor seal quickly. Look at both fittings with good light, and run a dry fingertip around each joint — fuel is easier to feel than to see.

Then start the engine and check again warm. Vibration and heat expose leaks a static test misses. If you see weeping at a clamp, do not simply crank it tighter; pull the joint apart and confirm the hose was fully seated on the barb, because an unseated hose will not seal at any clamp torque.

Finally, tidy up. Dispose of drained fuel properly rather than returning it to the tank if it looks cloudy or smells stale, and check the new hose after your first ride or two — new rubber takes a small set as it conforms to the fitting. For more background on how fuel quality and storage habits shorten hose life, our full guide to dirt bike fuel line care covers that ground in detail.

Related Shopping Categories

Shop Fuel Lines for a 2017 Cobra CX50FWE Dirt Bike.

Shop Fuel Line Clamps for a 2017 Cobra CX50FWE Dirt Bike.

Shop Petcocks for a 2017 Cobra CX50FWE Dirt Bike.

Shop Fuel Filters for a 2017 Cobra CX50FWE Dirt Bike.

Shop Fuel Stabilizer for a 2017 Cobra CX50FWE Dirt Bike.

Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your dirt bike's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.