How to Change the Coolant in a 2011 Husaberg FE570: Your Complete MotoSport Guide
Shop parts for a 2011 Husaberg FE570 Dirt Bike.
Keeping your 2011 Husaberg FE570 running cool starts with routine coolant changes. This guide walks you through each step for changing the coolant, along with expert tips and unique considerations for this prized model to ensure a hassle-free maintenance experience.
What You Will Need
- Fresh coolant formulated for modern dirt bikes (compatible with aluminum components)
- Distilled water (for flushing, if desired)
- Basic hand tools including screwdrivers, pliers, and socket wrenches
- Catch pan or container
- Funnel
- Clean rags
- Replacement radiator cap or gaskets (if worn), as leaks can occur over time
Preparation
- Ensure the engine is completely cool–opening the system hot can cause burns from pressurized steam or coolant spray.
- Put the motorcycle on a stable stand, ideally with a level work surface.
- Consider rinsing the radiator fins & engine area with light water spray to remove dirt and debris before opening the system.
Step-by-Step: Changing Coolant on the FE570
- Remove the Seat & Shrouds (if needed): This allows easier access to the radiator cap and hoses. Use the seat release loop under the rear of the seat and appropriate fasteners for shrouds.
- Remove the Radiator Cap: With the cap facing up, loosen it slowly to release any built-up pressure.
- Drain the Coolant:
- Locate the lower radiator hose where it joins the water pump (left side). Place your catch pan beneath the connection.
- Loosen the hose clamp with a screwdriver or socket and slide the hose back to allow coolant to drain completely.
- Optional Flush:
- If the coolant is heavily discolored or overdue for replacement, refill the system with distilled water, reinstall the hose, and run the bike briefly to circulate. Drain again to remove old residue.
- Inspect and Clean:
- Wipe any old coolant from fittings and check the condition of all hoses, clamps, gaskets, and the radiator cap. Replace any cracked, swollen, or brittle parts.
- Inspect the water pump weep hole for signs of leakage. The FE570's unique engine angle leaves its weep hole facing forward–be aware this slot can collect dirt, so it's wise to check for debris and clear it gently if necessary.
- Refill with New Coolant:
- Using a funnel, pour coolant slowly into the radiator until the level is about 10 mm above the radiator fins when cold.
- Tilt and shake the bike slightly to burp out air pockets. Top off if necessary to maintain the proper level.
- Reinstall the radiator cap firmly.
- Reassemble Bodywork: Reinstall the shrouds and seat, ensuring secure fitment.
- Start and Check for Leaks:
- Start the engine and let it idle. Keep an eye on any potential leaks at the hose, water pump, or radiator seams.
- Once the engine reaches full operating temperature, shut it down, allow to cool, and confirm the coolant level. Add more if needed.
Key Tips for 2011 Husaberg FE570 Owners
- Unique Water Pump Consideration: The FE570 features two water pump seals separated by a weep hole. The engine's angled design leaves the weep hole facing forward, making it prone to dirt entry. A periodic check and cleaning of this area can help prevent premature seal wear and avoid coolant or oil contamination in the engine.
- Coolant Selection: Always use a high-quality motorcycle coolant compatible with aluminum. Avoid mixing different coolant types.
- Radiator Cap: The cap's gasket and spring wear over time–replace if there are signs of weeping or if unable to maintain pressure.
Why Routine Coolant Changes Matter
Changing the coolant every 2 years or 2,000 miles (whichever comes first) helps prevent internal corrosion, water pump seal wear, and overheating–all critical to preserving the performance of your 2011 Husaberg FE570. With attention to these model-specific details, you'll keep your ride cool and ready for the toughest trails.
Related Shopping Categories
Shop Radiators for a 2011 Husaberg FE570 Dirt Bike.
Shop Coolant for a 2011 Husaberg FE570 Dirt Bike.
Shop Temperature Sensors for a 2011 Husaberg FE570 Dirt Bike.
Shop Tools for a 2011 Husaberg FE570 Dirt Bike.
Shop Radiator Hoses for a 2011 Husaberg FE570 Dirt Bike.
Disclaimer: This guide is provided for general informational purposes only and is not intended to replace your motorcycle's official owner's manual. Always refer to your manufacturer's documentation for model-specific instructions, torque specifications, safety procedures, and maintenance requirements. If you are unsure or inexperienced, consider seeking assistance from a qualified mechanic or technician.
