This bearing kit is very high quality. I was very impressed with the fit and finish of everything especially the wheel spacers with the inner the o-ring. I always look for the highest quality parts and this definitely meets my expectations. I can't speak to the longevity yet but if the quality says anything then they should last a very long time.
Pivot Works Wheel Bearing And Collar Kit
- 7 Reviews
- 2 Questions
Pivot Works began operations in 1999 as the first company in the world to manufacture and market complete bearing and seal kits to the power sports market. The original supplier of chassis and suspension rebuild components for dirt bike and ATVs.
- An improvement over O.E.M. wheel collars, the O-ring seals out water / debris from hub between collar and axle.
- Resists corrosion and rust.
- Military spec hard anodized.
- Includes bearings, seals, water tight wheel collars, and extra set of O-rings.
- Includes Chevron Starplex® EP lubricating grease to ease installation.
- Backed by a lifetime replacement offer!
I will always choose Pivot Works over A-Balls. The extra couple bucks is nothing compared to the next level quality you get.
I purchased this kit when I rebuilt an 07 Yz125 for the front and rear wheels. Fit perfect and have lasted well.
Installation went smoothly on my YZ125. Quality product!
Overall a great product. A much needed upgrade over O.E. spacers. The o-rings really do their job.
The only flaw in this particular fit (2000 RM250) is you have to re-use the right side O.E. spacer along with the Pivot Works kit. If the original RH side is trashed, you will need to visit the dealer for a replacement.
I put this kit into a 2005 RM250 and did not need to reuse any of the original spacers.
Not bad, but Pivot Works have skimped on the grease............ kinda misses the point of a good bearing?
The bearings and dust seals fit and work great however The collars would not work for my 02 yz250f. Not even close.