The EXO-R420 helmet continues to set a new standard for Scorpion EXO's full face street helmets at a very competitive price point. An all new advanced LG polycarbonate shell is more aerodynamic and smaller resulting in an ultra-lightweight SNELL-approved helmet. The aero-tuned ventilation system uses a large top vent and mouth vents engineered to allow more airflow to the rider's head while maintaining low noise levels. The EXO-R420 now features Scorpion's new Elliptec II faceshield with a latching shield locking mechanism located in the lower center of the shield. This makes the faceshield more secure and provides a tighter seal against the gasket. The faceshield can be easily removed without tools, and the EverClear No-Fog coating helps keep your vision clear in cold and damp environmental conditions. The KwikWick II liner is moisture-wicking, anti-microbial, quick drying and can be easily removed and is machine washable. The EXO-R420 is an updated true high performance helmet at an unbeatable price.
Ellip-Tec II Ratchet System - Easy, Secure, tool-less faceshield changes in seconds. This makes the faceshield more secure and provides a tighter seal against the gasket.
EverClear No Fog Faceshield - Optically-clear shield with state-of-the art fog free technology. Anti-scratch hardened coating. 100% UV protection.
KwikWick II Liner - KwikWick II anti-microbial fabric keeps you cool and dry in warm weather, warm in cool weather. Liner is easily removable and washable.
KwikFit - KwikFit cheekpads allow easy on and off of the most common styles of eye glasses.
Emergency Release System - Tabs located on the neck roll allow easy removal of the cheek pads by trained emergency medical personnel.
Aero-Tuned Ventilation - The aero-tuned ventilation system uses a large top vent and mouth vents engineered to allow more airflow to the rider's head while maintaining low noise levels.
FaceShield Lock System - Securely locks the faceshield in place.
SNELL M2015 / DOT-218 Approved.
Note: Helmet ships with a Clear faceshield, other tints available separately.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.