The all new EXO-CT220 was designed to offer a modern, protective and functional product for those riders that need more than just an old school open-face helmet. The versatile EXO-CT220 can be configured with a face shield for serious wind blocking or switch the shield for a sun blocking visor for more of that wind-in-your-face feel. The face shield is specially extended in length and reduces turbulence inside the helmet by re-directing the air flow under the helmet instead of the interior.
Advanced LG Polycarbonate Shell - Developed exclusively by Scorpion, this industry-leading polycarbonate shell is engineered to minimize weight and disperse impact.
SpeedView Retractable Sun-visor with Three (3) Position Settings - The retractable sun-visor incorporates Everclear anti-fog technology on both sides.
KwikWick II Liner - Anti-microbial fabric liner with triple-density foam and hypo-allergenic properties.
KwikFit Cheek Pads Accommodate Eyewear - Kwikfit cheek pads allow easy on and off of the most common styles of eye glasses.
Anti-Turbulence, Extended Face Shield with Locking Pin.
Open-Face Peak Visor - Included with helmet.
Aero-Tuned Ventilation System - Maximizes movement of hot air out of the helmet.
Communication System Speaker Pockets.
Double D-Ring Chin Strap.
Two Shell Sizes - Having two shell sizes helps to optimize weight, fit and comfort across the entire size range of XS - 2XL.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.