The Lane Splitter is crafted around Biltwell's proprietary ABS outer shell and features a shock-absorbing EPS liner with hand-stitched interior padding, cheek pads and BioFoam chin bar cushion for comfort. Generous vents in the chin bar get the air flowing and the outlet in back lets hot air escape. The Lane Splitter shield boasts extremely accurate optics and simple hinge mechanics for high style and easy removal for replacement or cleaning. A brass peg and hole configuration on the left side of the shield offers speedy opening and secure closing with little fanfare or complication. Mesh pockets are included in the ear recess - perfect for aftermarket drop-in communication systems.
Injection-molded ABS plastic outer shell is rugged yet lightweight.
Three-piece Expanded Polystyrene (EPS) safety shell dissipates impact loads and fortifies helmet structure without compromising comfort.
Molded urethane chin bar pad features front and side vents for cooling airflow.
CE-certified polycarbonate shield is anti-fog and anti-scratch for safety and durability.
Removable / replaceable comfort liner and cheek pads feature brushed fleece Lycra touch points to absorb and evaporate perspiration.
Chin strap features brushed fleece Lycra touch points for comfort and an adjustable strap end retainer.
Built-in recesses for various aftermarket audio and comms systems.
Meets DOT and ECE safety standards.
Note: Helmet ships with Clear shield, all other tints available separately.
There have been no questions asked about the Biltwell Lane Splitter Helmet - Factory.
20.8 - 21.37in (53 - 52.25cm)
6 5/8 - 6 7/8
21.5 - 22in (54.25 - 55.75cm)
6 7/8 - 7 1/8
22.1 - 22.6in (56 - 57.25cm)
7 1/8 - 7 3/8
22.75 - 23.25in (57.5 - 58.75cm)
7 3/8 - 7 5/8
23.37 - 23.87in (59 - 60.25cm)
7 5/8 - 7 7/8
24 - 24.5in (60.5 - 61.75cm)
7 7/8 - 8 1/8
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.