Historic shapes and colors meet modern design. The Legends helmets immortalize riders and achievements that will never be forgotten. Comfort, protection and ventilation are key elements of these helmets that meet today's highest standards. The X3000 carries Agostini's signature and includes the contoured chin piece just as he liked it so that he could lean right up against the gas tank. It also features a dual button visor that can be opened with the left hand alone.
Clean lines, iconic colors, minimalist combinations: simplicity and elegance mark the early versions that led to the retirement of single-color graphics. The bold contours on the chin piece and the contrasting lower plate give it an even thinner appearance. Super AGV reinvents racing as we once knew it.
Shell in fiberglass engineered with three sizes, EPS structure developed in three sizes.
Visor on-off air vent with channels hollowed in the shell.
Premium interiors with genuine leather, suede fabric and embroidered logo.
Fully removable and washable interiors (neck roll excluded).
Anti-scratch visor with micro-opening system.
Double-D retention system.
Homologation: DOT / ECE2005.
Notes: Limited Edition. Ships with a Clear shield; all other tints sold separately.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye-brows and across the largest portion of the back of the head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.