Troy Lee's new SE4 Composite Helmet comes with MIPS, incorporating brain rotational protection.
This featherweight helmet comes in at only 1425 grams. This helmet comes with 20 intake ports to channel cool air around and over a rider's head, forcing hot sweaty air out through six rear exhaust ports.
MIPS brain protection system, reduces rotational forces to the brain.
EPP (Expanded PolyPropylene) chin bar for lightweight, durable protection.
Three shell sizes to more accurately fit a variety of head sizes and rider ages, improving overall safety.
Anatomical - 3D" contoured cheek pads with emergency release system for EMS responders.
Plastic visor screws and brass inserts for easy impact break-away.
Exceeds certifications for DOT FMVSS 218, ECE 22.05 and AS/NZS 1698.
MIPS Patented Brain Protection System: MIPS stands for Multi-directional Impact Protection System, it is a revolutionary technology that lets the helmet slide relative to the head, adding more protection against rotational violence to the brain caused by angled impacts.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.