The Speed and Strength SS1600 full face helmet comes lined with a removable and washable Cool-Core moisture-wicking liner and is built with an A.T.P.A. Advanced Thermo-Poly Alloy shell that meets or exceeds DOT and ECE 22-05 standards. The 1550 gram motorcycle helmet contains a Lockdown shield security system and an Air Strike direct course ventilation system providing proper airflow circulation. A DVD Drop Visor Design is included for sun protection and an All Clear! optically-correct, anti-scratch, anti-fog and UV-resistant clear face shield. Lock 'N Load rapid conversion shield replacement system.
A.T.P.A. Advanced Thermo-Poly Alloy Shell: Advanced thermo-poly alloy shell for lighter weight and increased impact resistance.
Cool-Core Liner: A lightweight, moisture-wicking fabric liner that keeps the rider dry and comfortable. The liner is removable and washable.
Air Strike Direct Course ventilation system: Adjustable and strategically placed intake vents combined with rear exhaust vents and integrated cooling channels in the EPS liner provide maximum airflow through the helmet.
Lock 'n Load rapid conversion shield replacement system: Quick-release lever allowing for quick and easy, tool-less shield changes.
Lockdown shield lock security system: Single-action locking mechanism allows the face shield to be locked in a closed position.
DVD Drop Visor Design: Single action, internal tinted retractable sun visor for daytime riding.
All Clear! sight system: Optically correct, anti-scratch, anti-fog, and UV-resistant face shield provides clear vision and protection.
Meets or exceeds DOT and ECE 22-05 standards.
Weight: 1550 grams.
Note: Sold with Clear shield. Tinted shields are sold separately and are for daytime use ONLY.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.