Pivot Works Rear Wheel Bearing And Collar Kit

$50.99 (15% off)
3.40 5 4
3.40 out of 5 stars
Pivot Works Rear Wheel Bearing And Collar Kit
Pivot Works Rear Wheel Bearing And Collar Kit
  • Description
  • Reviews (4)
  • Q&A (2)
  • Fitment

Pivot Works began operations in 1999 as the first company in the world to manufacture and market complete bearing and seal kits to the power sports market. The original supplier of chassis and suspension rebuild components for dirt bike and ATVs.

  • Improvement over O.E.M. wheel collars, O-ring seals out water and debris from hub between collar and axle.
  • Military spec hard anodized.
  • Resists corrosion and rust.
  • Includes bearings, seals, watertight wheel collars, and an extra set of O-rings.
  • Includes Chevron Starplex® EP lubricating grease to ease installation.
  • Backed by a lifetime replacement offer!
3.4 out of 5 stars (4)
3.4 out of 5 stars
5 star   1
4 star   2
3 star 0
2 star   2
1 star 0
See Terms and Conditions
1-4 of 4
Overall 5 out of 5 stars
Verified Purchaser
Location: Virginia Beach
Great fit!

Installation went smoothly on my YZ125. Quality product!

Overall 4 out of 5 stars
Verified Purchaser
Location: New York
Could be better....

Overall a great product. A much needed upgrade over O.E. spacers. The o-rings really do their job.
The only flaw in this particular fit (2000 RM250) is you have to re-use the right side O.E. spacer along with the Pivot Works kit. If the original RH side is trashed, you will need to visit the dealer for a replacement.
I put this kit into a 2005 RM250 and did not need to reuse any of the original spacers.

Overall 2 out of 5 stars
Top 1000 Contributor
Location: Tabuk, Saudi Arabia

Not bad, but Pivot Works have skimped on the grease............ kinda misses the point of a good bearing?

Overall 2 out of 5 stars
Collars didnt fit

The bearings and dust seals fit and work great however The collars would not work for my 02 yz250f. Not even close.

1-4 of 4
Total Questions (2)
Questions with answers:
Questions without answers:
1-2 of 2
Jeremy Over 6 months ago
Dust cap?
I'm wondering if I still need to use my dust caps on the rear with this kit for my 2001 yz250? Thanks
MotoSport Staff Expert
Over 5 months ago
Yes you would still use the dust caps.
russellmania Over 11 months ago Location: Tahoe City, CA, USA
Can you provide ID and OD measurements for the fitment of wheel bearings and collars?
Inside diameter measurements. outside diameter measurements. For fitment, all size specs should be provided.
MotoSport Staff Expert
Over 11 months ago
Unfortunately Pivot Works does not provide that information. I would try contacting them directly at http://www.pivotworks.com/Contact.aspx or 515.402.8000
1-2 of 2