When you take the most advanced performance technology and precision craftsmanship, coupled with professional athlete input and cutting edge styling, it calculates into an unbeatable formula that the One Industries design lab has used to create the Gamma helmet.
Engineered shell for optimal strength-to-weight ratio.
Superior impact protection with progressive energy-absorbing dual-density inserts.
Increased cooling from flow-through ventilation.
Easily cleaned removable inner liner and cheek pads.
Plush comfort with moisture management liner.
Large peripheral visibility; great goggle fitment.
Meets or exceeds the following safety standards: SNELL / DOT, ECE 22.05.
Constructed from a pre-preg, reinforced fiberglass shell, for a feather-lite feel that One Industries' athletes demand while not sacrificing the protection they need at the highest level of competition. Heat and sweat are not an issue with the flow-through ventilation system and moisture-wicking Nylex liner. Riders can now push harder and further in what is possibly the coolest helmet environment available in motocross.
Write a Review
Enter to Win $500
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.