The N-86 is simply a great full-face helmet at a great price: it is light, packed with features typical of high-end helmets and comes in a wide range of solid colors and graphics.
Lightweight aerodynamic polycarbonate shell with built-in spoiler for improved stability.
VPS (Vision Protection System) - short dark shield mounted on the inside of the shell and moving independently from the clear shield. It is easily operated by a rotating slider on the left side of the helmet. It is treated to be anti-fog and anti-scratch and can be changed easily.
Fully removable and washable Clima-Comfort(r) liner snaps on with wrap-around cheek pads and neck-roll for wind-noise reduction.
The multi-color liner is treated to be anti-bacterial, is wicking and breathable.
The cheek-pads are separate for custom-fitting options.
The Eyewear-Adaptive feature accommodates eyeglasses.
Reflective patch on the back neck-roll increases rider safety at night.
Dual top vent with exhaust vent in the rear spoiler and chin-bar vents operate with glove-friendly sliders.
Optically correct, push-button quick-change shield is optically correct and offers UV-400 protection.
Multi-position anti-scratch shield accepts the new high-performance Pinlock(r) anti-fog protection.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.