The New Power Commander V is loaded with tons of new features. It is compatible with 2009 and newer bike models. On select models, gain control over fuel delivery AND timing with the new Power Commander V with fuel and ignition control. The best of both worlds, now you can realize all the benefits of the Power Commander V and the Ignition Module 5 wrapped in a single enclosure. This Power Commander V is available for select twin cylinder engines. Below you will find some Power Commander V features.

• Reduced size from PCIII USB (less than half of the size of PCIII).
• USB powered from computer (9 volt adapter is no longer needed for programming).
• 2 position map switching function built in (map switch not included).
• Gear input (allows for map adjustment based on gear and speed).
• Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature).
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables).
• Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes.
• 10 throttle position columns (up from 9 on PCIII USB).
• Enhanced "accel pump" utility (increased adjustment and sensitivity ranges).
• Retains all of the standard Power Commander V fuel control features.
• Allows +/- 20 degrees of timing adjustment.
• Map switch input: Change maps on the fly.
• Adjust timing per cylinder.
• Raise your Rev Limit (only available on select models).
• Built in launch limiter.
• Fuel and ignition adjustment.