Ride Engineering Fender Eliminator Kit

Fits perfect and looks great. Takes about 1 hour to take stock one off and install new one.

Bought this instead of spending a ton more on another product. Simple and easy to install. Really cleans up the bike!

Very easy to install. The hardest part was getting inside the fairing to disconnect the wires. Didn't have a spot for little white license plate light. If your state requires it, then you mighty want to try a different one.

Well thought out design and easy install.

What a great product, installation was easy, great directions, took about 30 minutes and gets rid of that nasty stock fender....

What can I say? Ordering was easy, shipment was fast and the part is a must have for anyone looking to do away with that gawd awfull rear fender contraption. The kit has everything you will need to install onto your bike. Instructions are clear enough, the brackets are nicely made with a quality black finish. All I would suggest is to take your time. With my particular bike I had to disassemble the whole right rear side of the bike to get at the wiring (2012 ZX6R) no fault of the kit, this is more coming from a DIY'er point of view to go easy. Don't be scared to do it yourself just take your time and give yourself a couple hours to complete the installation. 'Cause in the end your gonna love the look as much as I did mine. Oh and I reused the stock signals. Just remove the rubber extension piece from the signal (as the instructions state) and they're good to go. With the extensions gone they sit on the bracket nicely and don't protrude out the sides. I think they look factory, but nicer. Should have been made this way IMO.

Nice quality, I'd buy again if there were ever a reason to.

One of the cheapest FE that allow you to use your stock turn signals. Works great on 12 r6. Have had it for 3000 miles. I just got my integrated tailight so i just took off the turn signal holders! Looks even better now. For the price and adjustability you cant beat it!

Easy install Perfect fit

it was as expected. i always keep the stock turns so they fit back on perfectly