the first one screwed in ok, but the second one not @ tight @ the first one broke off, had to take to bike shop to remove! MotoSport sent me new ones, but $30.00 later @ the bike shop was not a good value. Still needed them and they work good, just don't put them in very tight.
Motion Pro Bleeder Valves [obs]
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!Write Your Review
Excellent product, easy to install, easier to use!
The bleeders didn't seal right and the one snapped off and I had to use a left handled bit to get it out so I just what back to the stock method...
This part works better than your stock screw. But the micro bleeder's, out perform these...
Im not much one for bells and whistles on my bikes, but I will say that these will help prolong the life on your fork seals and they help keep dirt out of the forks by not having to open up the bleeders with a screw driver.
I would recommend these to anyone who rides alot
It just flat out works, and I haven't lost one of the little screws this replaces since I installed them because there is no reason to take them out except to rebuild your forks.
fits good on the 2002 CR250R, no leaks, convenient for discharging pressure when on a ride.
easy to install
These little guys make bleeding your forks a no brainer. Easy to install and easier to use.
this makes life a lot easier for me because my air fork bleeder screw isent accessible and a screwdriver wouldn't reach it. now all i have to do is push a button to bleed the air out of my forks.
I like them. Easy to install and nice and easy for bleeding the forks. My friends are using screw drivers to bleed theirs, I yawn, stretch, push a button and done before they finish pulling the first screw.
leaks badly, not a good fit for Yamaha at all
They work, but after reading the other reveiws, and working VERY hard to not break them while putting them in place, I have to say that its just better to buy the right size screwdriver to fit your stock brass screws. They will be a real "PITA" to take out if they break off.
Good product. Makes bleeding forks easy, you're done at the push of a button. Easy to install, they just screw in where your bleeder screws did.
A must on any mx'r, great product that is easy to install at a great Price!
Dont buy this, any bar tweak when you lay it out it breaks the threads off inside the forks. Just spend the 40 bucks and get the Moose Racing fork bledder valves.
these bleeders stand very tall and get to close to the bars for my comfort. one good wreck and these will be bent by the bars causeing some major suspension issues, when its not necessaryly needed
a lil tall had to adjust my bars, but made it easy to release the pressure in the forks, installed on a 2005 rm 125 and 2001 rm 250.
I wasn't sure if I should spend $20 on something that is not a necessity since you can bleed the air from your forks by simply taking out two screws. I got them anyway and I have decided they are worth the price. They save time and have increased the life of my fork seals since I remove the air constantly. A word of caution during installation... I was advised that these are somewhat fragile due to their small size and the fact that they are hollow by the nature of their design. The threaded portion can easily be snapped off inside your fork cap if they are tightened too much. I was advised to put them in as tight as you can with your fingers, and then tighten them 1/4 turn more with a wrench.