Years of the same commitment, passion and dedication went into the development of the revolutionary Leatt-Brace and continues with every new product being developed at Leatt. Backed by scientific research and the collaboration with highly esteemed players in the safety field, all their products benefit from these continuous efforts by Dr. Leatt and his team of designers and biomedical engineers at the Leatt Lab in Cape Town, South Africa, home of Leatt's research and development. It is their badge of honor. Their choice.
Quattro Force Control:
High tensile carbon matrix junior shell for premium high-energy impact protection.
3D in-molded multi-density V-Foam Plus for high and medium impact energy reduction.
360 Turbine technology uses a collapsible structure and reactive gel material to protect against multiple low-energy impacts.
360 Turbine technology allows the head to move freely inside the helmet to reduce brain-damaging rotational acceleration.
Reduced outer shell volume for reduction in:
Forces to the neck.
Momentum and rotational brain acceleration.
Optimized integration with Leatt neck braces:
360-degree helmet and neck brace match.
Rear clearance cut for riding.
Rear hyperextension impact platform.
Optimized weight to protection ratio; very light while maintaining superior safety.
Maximum ventilation for low speed:
Over 190 honeycomb vent holes.
Eleven large vent ports.
Hydration ready! Optional internal hands-free kit available (sold separately).
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.