Quick-change fog-free Proshield(tm) with sideplates.
Prolock(tm) shield locking system.
Alliance GT(tm) includes interchangeable internal DropShield(tm).
World Standard, meets DOT FMVSS 218 (US), ECE 22-05 (Europe), SAI AS1698 (Australia) and PSC (Japan) helmet safety standards. Does not ship with SAI or PSC certification stickers unless purchased from an authorized dealer in that country.
Note: Ships with clear shield. Image is for display only.
Once again, the Alliance helmet has grown and evolved to further improve upon a classic. Enter the Alliance GT(tm), the next iteration of helmet that is built for the rider that craves versatility.
Icon has kept the world-renowned comfort and ventilation, and added an inner DropShield(tm) for those rides that start before sunrise and end well after the sunset. The rider can keep their Clear Proshield(tm) attached for all light conditions but with the flip of a switch, engage a tinted shield located just above the brow.
The Alliance GT(tm) leads the industry by offering a variety of interchangeable lenses for the DropShield(tm) to customize your look and fit your riding needs.
The Alliance GT(tm) helmet's ventilation system consist of strategically-placed air intakes, vents, air channels, and exhaust ports. The main ingredient in venting the Alliance is the Icon(r) SuperVent system featuring oversized intake ports controlled by individual vent triggers, along with recessed supervents to reduce wind noise. When activated, air is forced directly into the helmet, at both high and low speeds. Air is channeled between the comfort liner and protective EPS liner, expelling through the exhaust ports for maximum comfort.
Continuing with Icon's commitment to excellence, the Alliance GT(tm) is constructed with premier manufacturing processes and stringent quality assurance procedures. This, combined with rigorous testing, assures that the Alliance GT(tm) meets the highest safety standards in the world (DOT, ECE, PSC, SAI).
Write a Review
Enter to Win $500
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.