Hotbodies Racing ABS License Plate Tag Bracket

Hotbodies Racing ABS License Plate Tag Bracket
Hotbodies Racing ABS License Plate Tag Bracket

$53.96 - $143.96
10% Off - Save up to $15.99

Description See Also: 1 Review 2 Questions Fitment
Item #HBD000S

Read More
1 Review
3.0 out of 5 stars
5 Star   0 4 Star   0 3 Star   1 2 Star   0 1 Star   0
Write a Review

Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!

Write Your Review Write a review to win $500
All Reviews
Sogeking Verified Purchaser
Houston, TX, USA
QA needs some attention. For a 2010 ninja 250.

So the stock mudflap and centerpiece of the tail cover have a barb on each side that splits in half when the mudflap (lower half) and tail cover centerpiece (upper half) are separated. These two halves fit in a grommet/damper and help secure the LH and RH tail covers. This product replace the mudflap and must include the bottom half of the barb, but they merely have a triangular protrusion that does not fit in the grommet. I used some clamping pliers to crush the triangle into a nub approximately the same size as the stock barb.

Also, it was missing nuts (the instructions said to use stock bolts and the supplied nuts, but there were none) so I had to run to the hardware store.

It did come with a license plate light (a single led hotglued in a hole.)

Make sure you put the license plate on before fastening the bracket to your bike. I assumed I'd be able to put it on last and that the holes would be exposed, threaded, or have a threaded well behind them because the instructions show the installation without the license plate, then a "finished" panel with the license plate on. That's not the case and I had to break down the tail end to redo.

Once it's on, it's fine. Plenty sturdy. Close gap around my tail light. Less work than fabricating my own, which I only do for my favorites.

If you get this for an '08-'12 ninja 250, you may have to crush a protrusion on the HB bracket with some pliers to make it fit in the stock grommet. You may have to buy 2 nuts to use with your stock bolts. It has a license plate light.

2 Questions
Answered:   2
Not Yet:   0
Location: Pittsburgh, PA, USA
Q: Will this bracket hit rear tire with an eight inch extension on rear wheel? Having problems losing license plate.?
1 year 12 months ago
There are not any specs for the size of the bracket
Expert MotoSport Staff
1 year 12 months ago
A: With the custom modifications to your bike I could not say for sure if it would fit or not. I would contact HotBodies directly for any specifications you need and take some measurements of your bike to compare. HotBodies Racng: or 800-555-2805
Q: Does this tag bracket have a tag light with it? cant tell with the pic?
Over 3 years ago
MotoSport Staff
Over 3 years ago Location: Portland, OR, USA
A: It will depend on the specific model whether it includes the license plate light or not, some models use the stock one, some are included. If you can give us a call or visit Hotbodies website,it can be determined if the kit specific to your bike will include one or not.
1-2 of 2
See all bikes that this part fits...
See Fitments