The all new GM-65 naked half helmet from GMAX is full of new design features that include a tool-less quick change sun shield system, dual-density EPS styro that allows for a lightweight small shell design and a GMAX sun shield that is UV-400 rated for 100% UV protection.
DOT approved thermo-plastic poly-alloy shell.
Retractable hard coated UV-400 sun shield that is designed for quick and tool-less removal and replacement.
Simple no-spring design for raising and lowering the sun shield.
Each helmet includes the UV-400 tinted sun shield installed from the factory and a clear UV-400 shield in the box.
Dual-density EPS styro allows for a low-profile fit while still delivering a DOT certified helmet.
Removable snap-in rear neck curtain for cool weather riding installs and removes quickly and easily.
Premium venting that reduces heat at the top of the head.
Fully removable CoolMax(r) comfort liner material draws moisture away from the head and dries quickly keeping you more comfortable.
High-quality painted shell.
Optional / replacement shields available (sold separately).
Write a Review
Enter to Win $500
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.