For four decades, Fox Head, Inc. has been a global leader in the action sports industry producing dynamic designs. The Fox Head logo is recognized as a brand synonymous with quality and innovation, while remaining true to MX.
Multi-Directional Impact Protection System (MIPS).
Soft density EPS liner cap.
Comfort - Dri Lex comfort liner.
Shell - Multi-composite shell construction technology.
Fit - Three shell and four EPS sizes for a precise fit.
Venting - 14 intake and four exhaust vents.
Firm density outer EPS liner.
Soft density inner EPS liner.
Certification - Exceeds SNELL 2010 and DOT certifications.
Multi-Directional Impact Protection System - MIPS
There is no such thing as a perfect crash. Conventional helmets are tested by dropping them vertically onto a rigid surface. MIPS has had 15 years of study and testing in Sweden by some of the world's leading researchers and neurosurgeons, based on a different principle - reality. Because in reality when you fall, your head most often hits the ground at an angle, creating rotation in the brain, which in turn can cause major damage. With MIPS, the helmet absorbs much of that damaging rotational energy, offering you radically better protection. And if, against all odds, you do fall vertically onto your head, a helmet with MIPS will protect you just as well as an ordinary helmet.
MIPS imitates the brain's protective fluid. The secret behind MIPS' unique patent comes from the human brain. The brain is surrounded by a low-friction cushion of cerebrospinal fluid. MIPS gives the helmet its own low-friction layer between the EPS and comfort liner, to absorb much of the energy created by an angled blow to the head. The combination of the brain's own protection and MIPS ensures maximum protection - simple and effective. In laboratory tests, adding the MIPS layer reduced rotational acceleration by 20 - 35%, dampening crash forces and decreasing stress to the brain.
Write a Review
Enter to Win $500
Write your review and you'll automatically be entered in our monthly drawing. Include an image or video to DOUBLE your chances to win!
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.