This model has been developed from the ground up to meet the expectations of today's rider. Ventilation has been maximized, weight is light and comfort is spot on! FLY has created the Elite to take the top spot in entry level helmets.
Durable and lightweight polymer shell.
Custom molded rubber trim with integrated nose guard helps keep rocks and debris away from your nose.
POV camera-friendly visor.
Three shell and four EPS sizes for a precise fit.
Comfort liner and cheek pads absorb sweat, while also providing plenty of ventilation.
Removable and washable interior.
Multi-port air induction cooling system includes nine intake and six exhaust vents that create massive airflow to keep your head cool.
High-Flow ventilation system is designed to precisely align the comfort liner and EPS (expanded polystyrene) to maximize airflow.
High-Flow mouthpiece allows plenty of airflow and is replaceable.
Includes soft fleece helmet bag.
Cold weather kit includes a breath guard and vent plug kit.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.