EVS Sports has become the leader in innovation and advanced technology, developing head to toe products for the majority of today's extreme sports athletes. What started out as one knee brace has evolved into an extensive line of knees braces, neck supports, helmets, chest / back protection and a long list of protective gear products to keep any athlete safe when doing what they love. EVS Sports pours the same amount of dedication and determination into their products as you do into becoming the best that you can possibly be.
Lightweight thermoplastic shell: 1595 grams.
RAM Air Cooling System.
Internal EPS ventilation channels.
Oversized intake and exhaust ports for maximum airflow.
Anti-scratch, anti-fog and UV-resistant face shield.
A: No, the EVS Dual Sport Venture Helmet is ECE certified. Which of the two certifications is the best is a highly debated questions. ECE certification is the most up to date, rigorous and the most recognized worldwide.
A: The EVS Dual Sport Venture Helmet is not intended to be worn with goggles under the shield. There would likely not be enough room for most goggles. You may be able to fit sunglasses/glasses under the shield.
1. Measure your head size. To do this, pass a tape measure horizontally around your head at a height of about one inch above your eye- brows. When done properly, you will have measured the largest part of your head.
2. Check your measurement with the helmet sizing chart and select the closest size. As the helmet may not always meet your head size exactly, and your head measurement may fall between two sizes, first try the smaller size.
WHEN YOU RECEIVE YOUR HELMET
1. Expand the helmet opening by pulling outwards on each chinstrap, and slide your head into the helmet. If you are unfamiliar with helmets you may be reluctant to pull the helmet down, as it may feel too tight. Even if the helmet is difficult to put on, please use the smallest helmet possible. The helmet should feel snug. If the helmet is not tight, it is too big for you. New helmets will break in and loosen slightly over time.
2. Once the helmet is on:
Check that the helmet inner lining fits snugly all around your head.
Check that the top pad presses on the top of your head.
Check that the cheek pads press up against your cheeks. When you open and close your mouth, you should drag your teeth along the inside of your cheeks.
Check to make sure that you cannot easily slide your finger into the helmet along the side of your temple.
Hold the helmet with one hand on each side. Without moving your head, try to move the helmet up and down, and side to side. You should feel the skin of your head and face being pulled as you try to move the helmet. If you can move the helmet around easily, it is too big. Try a smaller size. Please note that during this check, the chinstraps should be properly fastened.