DMP Turn Signal - Short Stalk

Carbon With Clear Lens
Carbon With Clear Lens

$26.99 $29.99
10% Off - Save $3.00

  • Description
  • 4 Reviews
  • 3 Questions
Description Item #DMP0008

DMP LED Marker Lights are designed to function with all 12-volt motorcycle electrical systems as a single filament type flashing unit.

  • Super bright LED's.
  • O.E.M. type wiring harnesses available (sold separately).
  • Sold in pairs.
  • Notes: No running lights. NOT DOT approved - for off-road use only.

Read More
4 Reviews
4.0 out of 5 stars
5 Star   2 4 Star   0 3 Star   2 2 Star   0 1 Star   0
Top 250 Contributor
Christiansburg, VA
Very nice!

I started off with a set of Rumble Concepts, those went back immediately. They were flimsy and cheap plastic. These are very strong, very well built and of very high quality! I will NEVER hesitate to go DMP ever again, these are fantastic.

Verified Purchaser
St George, Ut
Bright, and simple.

Great little flashers! They fit anyplace you can drill a hole, and are easy to connect. They made my old 1991 Suzuki look like a completely different bike! Be sure to order an LED flasher relay as well, or they may not work. Some say they blink too fast without the relay, but mine just lit up dimly and did not flash at all. Relay is only 10-15 bucks, easy to install, and well worth it!

Filters accuracy

I filtered it by the bikes model, but when I went to put it on, the mount went through the original mounting hole. So much for the accuracy of the bike filters.
Shipping was extremely fast.

Prescott, AZ
Better instructions

My Kawasaki Z1000 has three wires for the signals and these lights had only two leads. I made a best guess but i dont feel very good about the installation because i am unsure. It would have been nice if the instructions addressed this issue.

Read More
3 Questions
Answered:   3
Not Yet:   0
Q: How do you go about hooking up the wires?
Over 6 years ago
Expert MotoSport Staff
Over 6 years ago Location: Portland, OR
A: Depending on your bike DMP makes a harness which makes it a lot easier. Other than that you'll probably need to splice them together.
Top 250 Contributor Top 500 Contributor
Over 3 years ago Location: Christiansburg, VA
A: They come with bullet style connectors, you can either wire some bullet style connectors onto your existing wiring harness or you can purchase the DMP adapters for your bike's brand (it's what I did and worked fantastic)

Here's the one I used for my SV-650 :
Q: Are these lights DOT approved?
Over 7 years ago
MotoSport Staff
Over 7 years ago Location: Tualatin
A: No these signals are not DOT approved. You may want to check with your local laws before ordering.
Location: LA
Q: Do they blink amber?
Over 7 years ago
Top 250 Contributor
Over 7 years ago
A: Yes they blink amber
Top 250 Contributor Top 500 Contributor
Over 3 years ago Location: Christiansburg, VA
A: Yes they do, the LEDs are amber and there is small amber window on the the outside of the signal to help motorists beside you see the indicator.
1-3 of 3

Read More