DMP Turn Signal - Mid Oval

$26.99 (10% off)
4.00 out of 5 stars
Black/Amber Lens
Black/Amber Lens
  • Description
  • Reviews (1)
  • Q&A (3)

DMP LED Marker Lights are designed to function with all 12-volt motorcycle electrical systems as a single filament type flashing unit.

  • Super bright LED's.
  • O.E.M. type wiring harnesses available (sold separately).
  • Sold in pairs.
  • Notes: No running lights. NOT DOT approved - for off-road use only.
4.0 out of 5 stars (1)
4.0 out of 5 stars
5 star 0
4 star   1
3 star 0
2 star 0
1 star 0
See Terms and Conditions
1-1 of 1
Overall 4 out of 5 stars
It may be my own fault

They work great except for if anything runs into them the rubber gasket can rip. I ordered new blinkers already I have only had these for a month. They are great if you never have saddle bags on or anything of the sort.

1-1 of 1
Total Questions (3)
Questions with answers:
Questions without answers:
adlin20 Location: Keller, Tx
1-3 of 3
adlin20 Over 6 years ago Location: Keller, Tx
What is the lenght and width of the lights?
What is the overall lenght and the width of these lights?
MotoSport Staff
Over 6 years ago Location: Tualatin
DMP does not provide any dimensions for their signals but the length on these are about 2.5" from the base of stalk to the end of the lens.
MotoSport Staff Expert
Over 6 years ago Location: Portland, OR
3.1 inches long including the stalk 1.1 inches wide or top to bottom if you're looking at the lens and the lens is 1.88 inches long
dbrayman Over 6 years ago
Does the leds blink amber?
MotoSport Staff Expert
Over 6 years ago
yes they blink amber.
ShowDown Over 7 years ago Location: Tampa
Bulbs, does it have double filament or are they only single?
Do these signal lights come in a front and rear model (3-wires in the front and 2-wires in the rear)
Top 25 Contributor
Over 7 years ago
These T/S have LEDs so do not have filaments. These are a two wire set up so are intended as turn signals only not running lights
1-3 of 3