Competition Werkes Light Werkes Integrated LED Tail Light

$59.77 (40% off)
3.50 5 5
3.50 out of 5 stars
Competition Werkes Light Werkes Integrated LED Tail Light
Competition Werkes Light Werkes Integrated LED Tail Light
  • Description
  • Reviews (5)
  • Q&A (1)
  • Fitment

Light Werkes integrated tail lights take your rear turn signals and move them into your tail light.

  • DOT compliant.
  • Ultra bright LEDs are visible day and night.
  • Include factory connectors (most models) for easy installation.
  • The LED matrix voids the need of ever replacing bulbs.
  • Image is for reference only. Product will vary according to bike model.
3.5 out of 5 stars (5)
3.5 out of 5 stars
5 star   2
4 star   1
3 star   1
2 star 0
1 star   1
See Terms and Conditions
1-5 of 5
Overall 5 out of 5 stars
Top 1000 Contributor Verified Purchaser
Location: Bargersville, IN, USA

Light fitment is spot on. The brightness is good even in daytime. Everything was plug and play with factory connectors. Could not have been any smoother.

Overall 5 out of 5 stars
Verified Purchaser
Location: Las Vegas, NV

Very easy installation. I stood over my friend's shoulder and instructed him. He is not a mechanic at all. The only thing is that I have to see if this led light isn't going to have to be changed out sooner that what's reasonable. Led lights usually aren't made very well from the factory: I wish I would have known that before I installed the kit. If the light goes out before a reasonable timeframe, I'll be sure to reply and rerate this product. So far it installed very clean, and looks really nice on my bike!

Overall 4 out of 5 stars
Verified Purchaser
Location: Jacksonville, NC
Simple modification

Great addition to any motorcycle, this looked very nice on my ZX-6R. You will have to cut, switch, and resplice the wires on the light because the positive and negative are flipped. Very simple to do however.

Overall 3 out of 5 stars
Location: Wahiawa Hi
To get turn signal to work

The light is good but you will need to switch the wire in the turn singal plug it it set as groung but it needs to be to the positive side to work. it is as simple as removing the wire insert and putting it in the other slot.

Overall 1 out of 5 stars
Location: Las Vegas, NV
Not Even Close!

This light looks good but the wire connectors werent even the right shape. When i went to the instructions they had, at most, a few words. This turned into a disaster where i had to cut all the wires and sodder the original connectors to the replacement light. Dont trust when the site says the parts are compatible with your bike!

1-5 of 5
Total Questions (1)
Questions with answers:
Questions without answers:
1-1 of 1
CBR600F4White 2 years 7 months ago
Does this include what is necessary to eliminate the big block and that holds my turn signals and license plate?
I basically want my tail light to be integrated and my license plate to be fastened right below it with nothing else. Any answers appreciated.
MotoSport Staff
2 years 7 months ago Location: Portland, OR, USA
This will not include the items to remove the stock fender. You will need to purchase a fender eliminator kit to get rid of the large stock fender. This is only an integrated taillight that will allow you to remove the stock signals, as they would be now integrated into this taillight.
1-1 of 1